Search results
Results from the WOW.Com Content Network
For example, round bar with diameters of even millimeters (or in the US, on the eighths of an inch) can usually be ordered from standing stock. Bar diameters of nonstandard sizes can also be obtained, but only as a separate mill run from the rolling mill. Thus they are much more expensive than the standard sizes, can take much longer delivery ...
In Canada and the United States, the Canadian Electrical Code (CEC) and the National Electrical Code (NEC), respectively, use the circular mil to define wire sizes larger than 0000 AWG. In many NEC publications and uses, large wires may be expressed in thousands of circular mils, which is abbreviated in two different ways: kcmil [ 1 ] or MCM ...
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
An end mill is a type of milling cutter, a cutting tool used in industrial milling applications. They can have several end configurations: round (ball), tapered, or straight are a few popular types. They can have several end configurations: round (ball), tapered, or straight are a few popular types.
A screw thread, often shortened to thread, is a helical structure used to convert between rotational and linear movement or force. A screw thread is an inclined plane wrapped around a cylinder or cone in the form of a helix, with the former being called a straight thread and the latter called a tapered thread.
Standards organizations define sets of sizes that are conventionally manufactured and stocked. For example, British Standard BS 328 defines 230 sizes from 0.2 mm to 25.0 mm. From 0.2 through 0.98 mm, sizes are defined as follows, where N is an integer from 2 through 9: N · 0.1 mm; N · 0.1 + 0.02 mm; N · 0.1 + 0.05 mm; N · 0.1 + 0.08 mm
Selection of the standard to be used is an agreement between the supplier and the user and has some significance in the design of the mill. In the United States, ASME has developed the standards B5.45-1972 Milling Machines and B94.19-1997 Milling Cutters and End Mills .
A minimum root-crest clearance of 0.01 in (0.25 mm) (diametral) between opposing threads with 10 tpi (threads-per-inch) or fewer, and 0.005 in (0.13 mm) for finer pitches. (This is also true for the minor diameters of the Centralizing Acme thread, though not its major diameters, where the allowance is made less than the PD allowance.)