Search results
Results from the WOW.Com Content Network
The Color Graphics Adapter uses a standard RCA connector for connection to an NTSC-compatible television or composite video monitor. [3] The connector on the card is female and the one on the monitor cable is male.
The aim of color calibration is to measure and/or adjust the color response of a device (input or output) to a known state. [1] In International Color Consortium (ICC) terms, this is the basis for an additional color characterization of the device and later profiling. [ 2 ]
An attempt by Apple to deal with cable clutter, by combining five separate cables from computer to monitor. Female port (20-pin) Digital Flat Panel (DFP) Used with the PanelLink digital video protocol. Deprecated. Made obsolete by DVI. 3D model of a UDI connector Unified Display Interface: Proposed to replace both DVI and HDMI.
Color management is necessary because different devices have different color capabilities and characteristics. For example, a monitor may display colors differently than a printer can reproduce them. Without color management, the same image may appear differently on different devices, leading to inconsistencies and inaccuracies.
An IEEE 1284 36-pin female on a circuit board. In the 1970s, Centronics developed the now-familiar printer parallel port that soon became a de facto standard.Centronics had introduced the first successful low-cost seven-wire print head [citation needed], which used a series of solenoids to pull the individual metal pins to strike a ribbon and the paper.
The Monochrome Display Adapter (MDA, also MDA card, Monochrome Display and Printer Adapter, MDPA) is IBM's standard video display card and computer display standard for the IBM PC introduced in 1981. The MDA does not have any pixel-addressable graphics modes, only a single monochrome text mode which can display 80 columns by 25 lines of high ...
Front and rear views of the TVM MD-3 cathode-ray tube monitor (Enhanced Graphics Adapter era). Note the DE-9 connector, cryptic mode switch, contrast and brightness controls at front, and the V-Size and V-Hold knobs at rear, which allow the control of the scaling and signal to CRT refresh rate synchronization respectively.
TGA graphics are built into the motherboards of Tandy computers. The PCjr uses a custom monitor with a unique 18-pin plug, [15] but an adapter (with the same DE-9 connector and pinout as IBM's CGA/EGA) can connect it to the IBM Color Display or similar 4-bit digital RGBI monitor. [16] The Tandy 1000 provides the DE-9 connector directly. [17]