Search results
Results from the WOW.Com Content Network
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
MDF (medium-density fiberboard) is a common material used for baseboard trim and molding. It is an engineered wood product manufactured from refined wood fibers combined with wax and resin binders. MDF is denser and more rigid than standard particle board. Compared to solid wood trim, MDF baseboard has the advantage of being consistent in ...
A soffit is an exterior architectural feature, generally the horizontal, aloft underside of the roof edge. Its archetypal form, sometimes incorporating or implying the projection of rafters or trusses over the exterior of supporting walls, is the underside of eaves (to connect a supporting wall to projecting edge(s) of the roof ).
Not every room has instant architectural interest, but you can create a dynamic look with the reasonably priced, paintable moldings and trims offered at any home improvement center.
The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the columns. The guttae or drip edge was mounted on the fascia in the Doric order, below the triglyph.
This formwork is assembled on site, usually out of insulating concrete forms (ICF). The formwork stays in place after the concrete has cured, and may provide advantages in terms of speed, strength, superior thermal and acoustic insulation, space to run utilities within the EPS layer, and integrated furring strip for cladding finishes.
In architecture a quirk is a small V-shaped channel used to insulate and give relief to a convex rounded moulding. To create the plastered corner, backing coat (browning) is plastered up to the staff bead, then the quirk is cut into the backing coat a little larger than the finished size.
Cyma: Moulding of double curvature, combining the convex ovolo and concave cavetto. When the concave part is uppermost, it is called a cyma recta but if the convex portion is at the top, it is called a Cyma reversa (See diagram at Ogee.) When crowning moulding at the entablature is of the cyma form, it is called a cymatium. [7]