enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Gender of connectors and fasteners - Wikipedia

   en.wikipedia.org/wiki/Gender_of_connectors_and...

   Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally assigned the designation male or female. [1] The female connector is generally a receptacle that receives and holds the male connector.

3. Piping and plumbing fitting - Wikipedia

   en.wikipedia.org/wiki/Piping_and_plumbing_fitting

   Piping or tubing is usually inserted into fittings to make connections. Connectors are assigned a gender, abbreviated M or F. An example of this is a "3 ⁄ 4-inch female adapter NPT", which would have a corresponding male connection of the same size and thread standard (in this case also NPT).

4. SMA connector - Wikipedia

   en.wikipedia.org/wiki/SMA_connector

   The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.

5. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   [1] The connection may be removable (as for portable equipment), require a tool for assembly and removal, or serve as a permanent electrical joint between two points. [2] An adapter can be used to join dissimilar connectors. Most electrical connectors have a gender – i.e. the male component, called a plug, connects to the female component, or ...

6. DC connector - Wikipedia

   en.wikipedia.org/wiki/DC_connector

   The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:

7. BNC connector - Wikipedia

   en.wikipedia.org/wiki/BNC_connector

   Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [4] using a special power or manual tool. [5] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used. [6]