enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_bellhousing...

   The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...

3. Turbo-Hydramatic - Wikipedia

   en.wikipedia.org/wiki/Turbo-Hydramatic

   The original version of the transmission had a 27-spline input shaft (shared with the THM200C and 2004R) which was a common failure point. In 1984, the 700R4 designed for use behind Chevrolet small block V8s received a 30-spline input shaft similar to those found on TH400 transmissions and which also used a different torque converter than its 2 ...

4. List of GM transmissions - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_transmissions

   Saginaw M26/27 transmission — 3 and 4-speed longitudinal light duty (less than 300 hp) wide ratio manual transmission made by GM at their Saginaw, Michigan factory; Muncie M62/M64 — 3-speed longitudinal transmission made by GM; Muncie SM318 transmission — 3-speed transmission used from 1954 through 1969 in both passenger car and truck ...

5. GM 4T80 transmission - Wikipedia

   en.wikipedia.org/wiki/GM_4T80_transmission

   Transmission broadcast codes in 2005 for the ECCC transmission are 5ABN and 5MMN. [1] The 4T80-E is a hydramatic transmission and was developed for use with V8 front-wheel-drive cars, and at the time exclusively the Cadillac Northstar engine. [3] It was designed with extreme power handling capabilities at the time.

6. Buick-Oldsmobile-Pontiac Assembly Division - Wikipedia

   en.wikipedia.org/wiki/Buick-Oldsmobile-Pontiac...

   Buick-Oldsmobile-Pontiac Assembly Division was a designation applied from 1933–1965 to a group of factories operated by General Motors. The approach was modeled after the Chevrolet Assembly Division where cars were assembled from knock down kits originating from Flint Assembly and a collection of sites Chevrolet used before the company became a part of General Motors in 1917.

7. GM 4T40 transmission - Wikipedia

   en.wikipedia.org/wiki/GM_4T40_transmission

   Final drive ratios include 3.63, 3.29, 3.05, and 3.91. This same transmission is used in the Saturn Vue Green Line hybrid vehicle with the addition of an auxiliary oil pump and hybrid-aware electronics. It is designed for 3.0–3.5 L engines producing up to 205 ft·lbf (278 N·m) of torque, but was also commonly mated to some versions of GM's 4 ...