Search results
Results from the WOW.Com Content Network
In electronics, motorboating is a type of low frequency parasitic oscillation (unwanted cyclic variation of the output voltage) that sometimes occurs in audio and radio equipment and often manifests itself as a sound similar to an idling motorboat engine, a "put-put-put", in audio output from speakers or earphones.
Ford has gotten about 100 complaints from F-150 truck owners who say the speakers in their vehicles are emitting a loud, annoying noise that sounds like static, or glass shattering, and which ...
Radio noise near in frequency to a received radio signal (in the receiver's passband) interferes (RFI) with the operation of the receiver's circuitry.The level of noise determines the maximum sensitivity and reception range of a radio receiver; if no noise were picked up with radio signals, even weak transmissions could be received at virtually any distance by making a radio receiver that had ...
A pair of headphones being tested inside an anechoic chamber for soundproofing. Soundproofing is any means of impeding sound propagation.There are several methods employed including increasing the distance between the source and receiver, decoupling, using noise barriers to reflect or absorb the energy of the sound waves, using damping structures such as sound baffles for absorption, or using ...
A noise-cancellation speaker emits a sound wave with the same amplitude but with an inverted phase (also known as antiphase) relative to the original sound. The waves combine to form a new wave, in a process called interference , and effectively cancel each other out – an effect which is called destructive interference .
Using a combination of sound absorption materials, arrays of microphones and speakers, and a digital processor, a restaurant operator can use a tablet computer to selectively control noise levels at different places in the restaurant: the microphone arrays pick up sound and send it to the digital processor, which controls the speakers to output ...
The braking effect is critical to speaker design, in that designers leverage it to ensure the speaker stops making sound quickly and that the coil is in position to reproduce the next sound. The electrical signal generated by the coil travels back along the speaker cable to the amplifier.
The RF is then coupled to the cable through the line driver as common-mode noise. Since the noise is common-mode, shielding has very little effect, even with differential pairs. The RF energy is capacitively coupled from the signal pair to the shield and the shield itself does the radiating.