Search results
Results from the WOW.Com Content Network
A compressor map is a chart which shows the performance of a turbomachinery compressor. This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor. A map is created from compressor rig test results or predicted by a special computer program.
With electrochemical compression of hydrogen, a pressure of 14500 psi (1000bar or 100MPa) is achieved. A patent is pending claiming an exergy efficiency of 70 to 80% for pressures up to 10,000 psi or 700 bars. [3] A single stage electrochemical compression to 800 bar was reported in 2011. [4]
Compressed hydrogen in hydrogen tanks at 350 bar (5,000 psi) and 700 bar (10,000 psi) is used for mobile hydrogen storage in hydrogen vehicles. [1] It is used as a fuel gas . Infrastructure
Dry vane machines are used at relatively low pressures (e.g., 2 bar or 200 kPa or 29 psi) for bulk material movement while oil-injected machines have the necessary volumetric efficiency to achieve pressures up to about 13 bar (1,300 kPa; 190 psi) in a single stage.
The simplest inlet to a centrifugal compressor is typically a simple pipe. Depending upon its use/application inlets can be very complex. They may include other components such as an inlet throttle valve, a shrouded port, an annular duct (see Figure 1.1), a bifurcated duct, stationary guide vanes/airfoils used to straight or swirl flow (see Figure 1.1), movable guide vanes (used to vary pre ...
The kilopound per square inch (ksi) is a scaled unit derived from psi, equivalent to a thousand psi (1000 lbf/in 2). ksi are not widely used for gas pressures. They are mostly used in materials science, where the tensile strength of a material is measured as a large number of psi. [4] The conversion in SI units is 1 ksi = 6.895 MPa, or 1 MPa ...
An example could be a 100-litre (internal volume) cylinder (V 1) pressurised to 200 bar (P 1) filling a 10-litre (internal volume) cylinder (V 2) which was unpressurised (P 2 = 1 bar) (resulting in both cylinder equalising to approximately 180 bar (P 3). If another 100-liter cylinder pressurized this time to 250 bar were then used to "top-up ...
Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.