enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw

3. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   A typical lag screw can range in diameter from 4 to 20 mm or #10 to 1.25 in (4.83 to 31.75 mm), and lengths from 16 to 200 mm or 1 ⁄ 4 to 6 in (6.35 to 152.40 mm) or longer, with the coarse threads of a wood-screw or sheet-metal-screw threadform (but larger).

4. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   This definition allows ambiguity in the description of a fastener depending on the application it is actually used for, and the terms screw and bolt are widely used by different people or in different countries to apply to the same or varying fastener. In British terminology, a cap screw is a bolt that has threads all the way to the head.

5. Self-tapping screw - Wikipedia

   en.wikipedia.org/wiki/Self-tapping_screw

   Self-tapping screws can be divided into two classes: [3] those that displace material (especially plastic and thin metal sheets) without removing it, known as "thread-forming" self-tapping screws, and self-tappers with sharp cutting surfaces that remove the material as they are inserted, termed "thread-cutting" self-tapping screws.

6. Differential screw - Wikipedia

   en.wikipedia.org/wiki/Differential_screw

   Many differential screw configurations are possible. The micrometer adjuster pictured uses a nut sleeve with different inner and outer thread pitches to connect a screw on the adjusting rod end with threads inside the main barrel; as the thimble rotates the nut sleeve, the rod and barrel move relative to each other based on the differential between the threads.

7. Rail fastening system - Wikipedia

   en.wikipedia.org/wiki/Rail_fastening_system

   Rusted chair screw Chair screw (French: Tire-fonds) A chair screw (also known as coach screw [16]) is a large (~6 in or 152 mm length, slightly under 1 in or 25 mm diameter) metal screw used to fix a chair (for bullhead rail), baseplate (for flat bottom rail) or to directly fasten a rail. Chair screws are screwed into a hole bored in the ...