Search results
Results from the WOW.Com Content Network
Techniques known since the 1940s and used in military communication systems since the 1950s "spread" a radio signal over a wide frequency range several magnitudes higher than minimum requirement. The core principle of spread spectrum is the use of noise-like carrier waves, and, as the name implies, bandwidths much wider than that required for ...
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
[5] [6] This is surpassed by the CPU-Z overclocking record for the highest CPU clock rate at 8.79433 GHz with an AMD FX-8350 Piledriver-based chip bathed in LN2, achieved in November 2012. [ 7 ] [ 8 ] It is also surpassed by the slightly slower AMD FX-8370 overclocked to 8.72 GHz which tops off the HWBOT frequency rankings.
Resistance of spread-spectrum system against narrowband interference. In a spread-spectrum system, the process gain (or "processing gain") is the ratio of the spread (or RF) bandwidth to the unspread (or baseband) bandwidth. Research suggests that it is one of the important factors in making decisions over the performance of system in jamming ...
The AMD 700 chipset series (also called as AMD 7-Series Chipsets) is a set of chipsets designed by ATI for AMD Phenom processors to be sold under the AMD brand. Several members were launched in the end of 2007 and the first half of 2008, others launched throughout the rest of 2008.
Direct-sequence spread-spectrum transmissions multiply the symbol sequence being transmitted with a spreading sequence that has a higher rate than the original message rate. Usually, sequences are chosen such that the resulting spectrum is spectrally white. Knowledge of the same sequence is used to reconstruct the original data at the receiving ...
The dynamic power (switching power) dissipated by a chip is C·V 2 ·A·f, where C is the capacitance being switched per clock cycle, V is voltage, A is the activity factor [1] indicating the average number of switching events per clock cycle by the transistors in the chip (as a unitless quantity) and f is the clock frequency.
Some users managed to overclock rev6. 68060 CPU-s (mask: 71E41J) up to 120 or 133 MHz. [ 1 ] [ 9 ] Motorola projected a performance of around three-and-a-half times that of a 25 MHz 68040 at the initial clock rate of 50 MHz for the 68060, this described as being "about 77 MIPS", [ 7 ] later adjusting such claims to three times the performance ...