enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flashing (weatherproofing) - Wikipedia

   en.wikipedia.org/wiki/Flashing_(weatherproofing)

   In earlier days, birch bark was occasionally used as a flashing material. [7] Most flashing materials today are metal, plastic, rubber, or impregnated paper. [8]Metal flashing materials include lead, aluminium, copper, [1] stainless steel, zinc alloy, other architectural metals or a metal with a coating such as galvanized steel, lead-coated copper, anodized aluminium, terne-coated copper ...

3. Tar paper - Wikipedia

   en.wikipedia.org/wiki/Tar_paper

   Tar paper is used as a roofing underlayment with asphalt, wood, shake, and other roof shingles as a form of intermediate bituminous waterproofing.It is sold in rolls of various widths, lengths, and thicknesses – 3-foot-wide (0.91 m) rolls, 50 or 100 feet (15 or 30 m) long and "15 lb" (7 kg) and "30 lb" (14 kg) weights are common in the U.S. – often marked with chalk lines at certain ...

4. Reglet - Wikipedia

   en.wikipedia.org/wiki/Reglet

   A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the surface, known as ...

5. Bituminous waterproofing - Wikipedia

   en.wikipedia.org/wiki/Bituminous_waterproofing

   From 1905 to 1988, The Paraffine Paint Co. of San Francisco had Malthoid as a trademark for waterproof and weatherproof building and roofing materials made of paper and felt in whole or in part. [13] However, it had become well known before that. [14] About 1913, Paraffine promoted its Malthoid roofing materials with a 16-page booklet. [15]

6. Flash (manufacturing) - Wikipedia

   en.wikipedia.org/wiki/Flash_(manufacturing)

   Flash, also known as flashing, is excess material attached to a molded, forged, or cast product, which must usually be removed. This is typically caused by leakage of the material between the two surfaces of a mold (beginning along the parting line [ 1 ] ) or between the base material and the mold in the case of overmolding .

7. Mark Williams' agent says center 'should have been a given an ...

   www.aol.com/mark-williams-agent-says-center...

   The agent for Charlotte Hornets center Mark Williams says the Los Angeles Lakers shouldn't have failed his client’s physical examination, a move that ultimately resulted in the trade being ...