Search results
Results from the WOW.Com Content Network
The flow stress is an important parameter in the fatigue failure of ductile materials. Fatigue failure is caused by crack propagation in materials under a varying load, typically a cyclically varying load. The rate of crack propagation is inversely proportional to the flow stress of the material.
A fault zone that displaces sealing units and reservoir rocks can act as a conduit for hydrocarbon migration. [6] The fault zone itself has higher storage capacity (specific capacity) than that of the reservoir rocks, therefore, before the migration to other units, the fault zone has to be fully filled [6] (Gif 3). This can slower and ...
In materials science, creep (sometimes called cold flow) is the tendency of a solid material to undergo slow deformation while subject to persistent mechanical stresses. It can occur as a result of long-term exposure to high levels of stress that are still below the yield strength of the material.
In materials science, material failure is the loss of load carrying capacity of a material unit. This definition introduces to the fact that material failure can be examined in different scales, from microscopic, to macroscopic. In structural problems, where the structural response may be beyond the initiation of nonlinear material behaviour ...
Thus, a point defining true stress–strain curve is displaced upwards and to the left to define the equivalent engineering stress–strain curve. The difference between the true and engineering stresses and strains will increase with plastic deformation. At low strains (such as elastic deformation), the differences between the two is ...
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
The difference between this model and the previous nucleation-and-growth models lies within the assumptions: the field boundary model assumes that grain size reduces in the dislocation creep field, and enlarges in the diffusion creep field, but it is not the case in the previous models.
Variables on the material points: positions, velocities, strains, stresses etc. are then updated with these rates depending on integration scheme of choice and a suitable constitutive model. Resetting of grid. Now that the material points are fully updated at the next time step, the grid is reset to allow for the next time step to begin.