Search results
Results from the WOW.Com Content Network
Moreover, for a given noise power spectral density (PSD), spread-spectrum systems require the same amount of energy per bit before spreading as narrowband systems and therefore the same amount of power if the bitrate before spreading is the same, but since the signal power is spread over a large bandwidth, the signal PSD is much lower — often ...
Resistance of spread-spectrum system against narrowband interference. In a spread-spectrum system, the process gain (or "processing gain") is the ratio of the spread (or RF) bandwidth to the unspread (or baseband) bandwidth. Research suggests that it is one of the important factors in making decisions over the performance of system in jamming ...
The purpose of overclocking is to increase the operating speed of a given component. [3] Normally, on modern systems, the target of overclocking is increasing the performance of a major chip or subsystem, such as the main processor or graphics controller, but other components, such as system memory or system buses (generally on the motherboard), are commonly involved.
Overclocking is the process of forcing your computer to run faster than it's intended to go, which can help you run advanced programs on an older PC.
However, the amount of overclocking is limited by the time for the CPU to settle after each pulse, and by the extra heat created. After each clock pulse, the signal lines inside the CPU need time to settle to their new state. That is, every signal line must finish transitioning from 0 to 1, or from 1 to 0.
The AMD 700 chipset series (also called as AMD 7-Series Chipsets) is a set of chipsets designed by ATI for AMD Phenom processors to be sold under the AMD brand. Several members were launched in the end of 2007 and the first half of 2008, others launched throughout the rest of 2008.
Some users managed to overclock rev6. 68060 CPU-s (mask: 71E41J) up to 120 or 133 MHz. [ 1 ] [ 9 ] Motorola projected a performance of around three-and-a-half times that of a 25 MHz 68040 at the initial clock rate of 50 MHz for the 68060, this described as being "about 77 MIPS", [ 7 ] later adjusting such claims to three times the performance ...
A related-but-opposite technique is overclocking, whereby processor performance is increased by ramping the processor's (dynamic) frequency beyond the manufacturer's design specifications. One major difference between the two is that in modern PC systems overclocking is mostly done over the Front Side Bus (mainly because the multiplier is ...