Search results
Results from the WOW.Com Content Network
1 Method of sampling of clay building bricks IS 5454 - 1978 2 Method of test for burnt-clay building bricks. IS 3495 (Parts I TO iv) 1976 3 Common burnt clay building bricks. IS 1077 - 1992 (D) Masonry Mortar; 1 Specification for sand for masonry mortars. IS 2116 - 1980 2 Code of practice for preparation and use of masonry mortar IS 2250 - 1981
This is an incomplete list of DIN standards.. The "STATUS" column gives the latest known status of the standard.. If a standard has been withdrawn and no replacement specification is listed, either the specification was withdrawn without replacement or a replacement specification could not be identified.
A shaft equipped with ladder rungs for personnel access. In civil engineering a shaft is an underground vertical or inclined passageway. Shafts are often entered through a manhole and closed by a manhole cover. They are constructed for a number of reasons including: For the construction of a tunnel
A building code (also building control or building regulations) is a set of rules that specify the standards for construction objects such as buildings and non-building structures. Buildings must conform to the code to obtain planning permission , usually from a local council.
Shaft mining or shaft sinking is the action of excavating a mine shaft from the top down, where there is initially no access to the bottom. [1] Shallow shafts , typically sunk for civil engineering projects, differ greatly in execution method from deep shafts, typically sunk for mining projects.
It is a comprehensive building code for regulating the building construction activities across the country which was first published in 1970. [7] Preliminary Draft Amendment No. 1 to NBC 2005 Part 11 "Approach to Sustainability" was put into circulation a preliminary draft amendment and BIS accepted the feedback from people till 15 March 2013. [8]
Installation information will need to be reviewed with electrical and plumbing trades to coordinate third-party service connections. A shop drawing is a drawing or set of drawings produced by the contractor , supplier , manufacturer, subcontractor , consultants, or fabricator .
Building codes determine the maximum deflection, usually as a fraction of the span e.g. 1/400 or 1/600. Either the strength limit state (allowable stress) or the serviceability limit state (deflection considerations among others) may govern the minimum dimensions of the member required.