Ads
related to: jeep dana 35 axlesextremeterrain.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
The Dana/Spicer Model 35 is an automotive axle. It has been manufactured by Dana Holding Corporation since 1985 when American Motors (AMC) sold its axle tooling equipment to Dana. [1] The axle was named AMC-15 when it was first made in 1962. [1] Dana upgraded the axle, and added IFS and Twin Traction Beam front axle variations. Dana 35 from a Jeep
The 10.5" 14-bolt differential and axle is quite popular with Jeep Wrangler owners who want to upgrade their standard Dana 30, Dana 35, or Dana 44 axle. While the 10.5" 14-bolt axle is heavier than the standard Dana axles offered on the Wrangler, it is much stronger.
The Jeep Comanche (designated MJ) is a pickup truck variant of the Cherokee compact SUV ... The standard rear axle was the same Dana 35 used in the Cherokee, except ...
In the 1960s, Jeep used a unique Dana 44 IFS setup, that was short lived. In the 1980s and 1990s, Ford used a form of IFS known as "Twin Traction Beam" (TTB). This Dana 44 had no axle tubes but attached to the driver side traction beam, which also acted as a cover plate, and had "open air" axles which traveled through the beams to the spindles.
Pages in category "Automobile axles" The following 16 pages are in this category, out of 16 total. ... Dana 35; Dana 44; Dana 50; Dana 53; Dana 60; Dana 70; Dana 80 ...
The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20. Almost all Dana 18 and Dana 20 input gears are 6-spline; the only exception is the one used with the 10-spline version of the T14 transmission.
Ads
related to: jeep dana 35 axlesextremeterrain.com has been visited by 100K+ users in the past month