Search results
Results from the WOW.Com Content Network
Alligator clip A crocodile clip manufactured by Mueller Electric. This device is a variation of Dusinberre's original crocodile clip design Crocodile clips, also called automotive clips, on a set of jumper cables Three crocodile clips: a bare standard-sized clip; a miniature clip in a yellow plastic boot; a large red Square D multi-function clip
Triaxial cable, often referred to as triax for short, is a type of electrical cable similar to coaxial cable, but with the addition of an extra layer of insulation and a second conducting sheath. Triax provides greater bandwidth and rejection of interference than coax, but is more expensive.
In 1941, the US Navy used a smaller version of the threaded N connector, the Type BN (Baby N), as the UG-85/U, UG-86/U, UG-114/U and UG-115/U. . In 1943, the British introduced a ¼ inch 50 ohm coaxial cable, and companies immediately developed many connectors for it.
Alligator and Crocodile clips – conductive clamps used for temporary connections, e.g. jumper cables; Board to board connectors – e.g. card-edge connectors or FPGA mezzanine connectors; Twist-on wire connectors (e.g. wire nuts) – used in low-voltage power circuits for wires up to about 10 AWG; Wire wrapping – used in older circuit boards
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
10BASE2 (also known as cheapernet, [1] thin Ethernet, thinnet, and thinwire) is a variant of Ethernet that uses thin coaxial cable terminated with BNC connectors to build a local area network. During the mid to late 1980s, this was the dominant 10 Mbit/s Ethernet standard.
Bad contacts are the cause of failure or poor performance in a wide variety of electrical devices. For example, corroded jumper cable clamps can frustrate attempts to start a vehicle that has a low battery. Dirty or corroded contacts on a fuse or its holder can give the false impression that the fuse is blown.
Most TNC connectors are 50-ohm type even when used with coaxial cable of other impedances, [citation needed] but a 75-ohm series is also available, providing a good SWR to about 1 GHz. [10] These can be recognized by a reduced amount of dielectric in the mating ends. They are intermatable with standard types.