enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. HDJ-1000 - Wikipedia

   en.wikipedia.org/wiki/HDJ-1000

   They are tightly closed dynamic headphones. Their impedance is 40 Ohms, with a maximum input of 3,500 mW and an output sound level of 107 dB/mW. The speaker unit type is a 50 mm dome. Connection is via a gold-plated 3.5 mm 3P mini plug and a 3.94 ft long single-coiled cable (approx. 9.84 ft when straight). The HDJ-1000 headphones weigh 9.5 oz ...

3. Line level - Wikipedia

   en.wikipedia.org/wiki/Line_level

   Headphone outputs and line outputs are sometimes confused. Different make and model headphones have widely varying impedances, from as little as 20 Ω to a few hundred ohms; the lowest of these will have results similar to a speaker, while the highest may work acceptably if the line out impedance is low enough and the headphones are sensitive ...

4. Headphones - Wikipedia

   en.wikipedia.org/wiki/Headphones

   Higher impedance headphones are more tolerant of amplifier limitations, but produce less volume for a given output level. Historically, many headphones had relatively high impedance, often over 500 ohms so they could operate well with high-impedance tube amplifiers. In contrast, modern transistor amplifiers can have very low output impedance ...

5. High impedance - Wikipedia

   en.wikipedia.org/wiki/High_impedance

   In analog circuits a high impedance node is one that does not have any low impedance paths to any other nodes in the frequency range being considered.Since the terms low and high depend on context to some extent, it is possible in principle for some high impedance nodes to be described as low impedance in one context, and high impedance in another; so the node (perhaps a signal source or ...

6. DI unit - Wikipedia

   en.wikipedia.org/wiki/DI_unit

   The electrical purpose of a direct box is to bridge the impedance of the input and output. Most electronic instruments and microphones cannot be plugged directly into the pre-amplifier inputs of mixing boards or recording devices because of impedance mismatch. Instruments are typically high impedance, whereas microphone inputs are low impedance.

7. Urbanears - Wikipedia

   en.wikipedia.org/wiki/Urbanears

   The Zinken is a pair of headphones released in July 2012, aimed at professional DJs and amateurs alike and made to work in various environments. [4] The headphones come with a Urbanears TurnCable, which is a reversible cable with rugged Kevlar inside, featuring a coiled section to allow more freedom of movement and a 6.3mm plug to be used with a mixer and a 3.5mm for use with a regular mobile ...