Search results
Results from the WOW.Com Content Network
Total dissolved solids include both volatile and non-volatile solids. Volatile solids are ones that can easily go from a solid to a gaseous state. Non-volatile solids must be heated to a high temperature, typically 550 °C, in order to achieve this state change. Examples of non-volatile substances include salts and sugars. [3]
DWSIM is an open-source CAPE-OPEN compliant chemical process simulator for Windows, Linux and macOS.DWSIM is built on top of the Microsoft .NET and Mono Platforms and features a graphical user interface (GUI), advanced thermodynamics calculations, reactions support and petroleum characterization / hypothetical component generation tools.
Total dissolved solids is another parameter acquired through a separate analysis which is also used to determine water quality based on the total substances that are fully dissolved within the water, rather than undissolved suspended particles. TSS is also referred to using the terms total suspended matter (TSM) and suspended particulate matter ...
Volatile suspended solids (VSS) is an analytical parameter that represents the undissolved organic matter in a water sample. More technically, it is a water quality parameter obtained from the loss on ignition of total suspended solids. [1] The heating of sample generally takes place in an oven at a temperature of 550 °C [1] to 600 °C.
The Mogden formula calculates cost as a combination (empirical coefficients) of volume, strength in terms of normal treatment oxidation demand and the suspended solids proportion. [1] Applicable to the whole works, it also approximates the cost for tested industrial waste water that may, if treatable, be lawfully sent to a regular sewage works.
Mixed liquor suspended solids (MLSS) is the concentration of suspended solids, in an aeration tank during the activated sludge process, which occurs during the treatment of waste water. The units MLSS is primarily measured in milligram per litre (mg/L), but for activated sludge its mostly measured in gram per litre [g/L] which is equal to ...
If the volatile content of the solid is primarily water, the loss on drying technique gives a good measure of moisture content. [5] Because the manual laboratory method is relatively slow, automated moisture analysers have been developed that can reduce the time necessary for a test from a couple of hours to just a few minutes.
In order to increase the calculation speed for viscosity calculations based on CS theory, which is important in e.g. compositional reservoir simulations, while keeping the accuracy of the CS method, Pedersen et al. (1984, 1987, 1989) [17] [18] [2] proposed a CS method that uses a simple (or conventional) CS formula when calculating the reduced ...