Search results
Results from the WOW.Com Content Network
Low pressure gas turbine for aircraft engine. AxSTREAM is a software suite designed by SoftInWay Inc. for the conceptual design of turbines and compressors and also thermodynamic calculations of existing turbomachinery on-design and off-design operation. The application area of the AxSTREAM software suite covers the design and redesign of ...
Active clearance control (ACC) is a method used in large aircraft gas turbines to improve fuel efficiency during cruise. This is achieved by setting the turbine tip clearance at more than one operating point and contrasts with passive clearance control which sets it for only one condition and is explained below.
The basic operation of the gas turbine is a Brayton cycle with air as the working fluid: atmospheric air flows through the compressor that brings it to higher pressure; energy is then added by spraying fuel into the air and igniting it so that the combustion generates a high-temperature flow; this high-temperature pressurized gas enters a ...
GE diagram of a turbine locomotive. Union Pacific operated the largest fleet of gas turbine–electric locomotives (GTELs) of any railroad in the world. The prototype, UP 50, was the first in a series built by General Electric for Union Pacific's long-haul cargo services and marketed by the Alco-GE partnership until 1953.
The General Electric LM2500 is an industrial and marine gas turbine produced by GE Aviation.The LM2500 is a derivative of the General Electric CF6 aircraft engine.. As of 2004, the U.S. Navy and at least 29 other navies had used a total of more than one thousand LM2500/LM2500+ gas turbines to power warships. [1]
The General Electric LM6000 is a turboshaft aeroderivative gas turbine engine. The LM6000 is derived from the CF6-80C2 aircraft turbofan.It has additions and modifications designed to make it more suitable for marine propulsion, industrial power generation, and marine power generation use.
The LMS100 comprises a low-pressure compressor, an intercooler, a supercore and a power turbine. The supercore (comprising a HP compressor, compressor rear frame, high-pressure turbine and intermediate pressure turbine) is a further development of the LM6000, which in turn was based on the CF6-80C2. The low-pressure compressor is from the 6FA ...
The propelling nozzle converts a gas turbine or gas generator into a jet engine. Power available in the gas turbine exhaust is converted into a high speed propelling jet by the nozzle. The power is defined by typical gauge pressure and temperature values for a turbojet of 20 psi (140 kPa) and 1,000 °F (538 °C). [18]