Search results
Results from the WOW.Com Content Network
These amplifiers are designed to amplify a very small "sense voltage" of 10 to 100 mV, in the presence of very large common-mode voltages of 5 to 30 V. DC precision (low input offset voltage) and high common-mode rejection ratio (CMRR) are distinguishing characteristics of these amplifiers. Some current sense amplifiers measure current flowing ...
Audio level at a listener's ears depends on the listening environment, listener position, speaker sensitivity as well as amplifier gain. For loudness compensation to work correctly the playback system must also accurately assume what volume level was used in mastering .
The sensitivity of an electronic device, such as a communications system receiver, or detection device, such as a PIN diode, is the minimum magnitude of input signal required to produce a specified output signal having a specified signal-to-noise ratio, or other specified criteria. In general, it is the signal level required for a particular ...
It was the best-known and best-selling amplifier in the annals of hi-fi. [2] ... 0.02%; Damping factor: 55; Input sensitivity: 2.5mV (MM), 150mV (line)
The impedance of a line input is typically around 10 kΩ. When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.
Here, k ≈ 1.38 × 10 −23 J/K is the Boltzmann constant and kT 0 is the available noise power density (the noise is thermal noise, Johnson noise). As a numerical example: A receiver has a bandwidth of 100 MHz, a noise figure of 1.5 dB and the physical temperature of the system is 290 K.
Charge amplifier for piezoelectric sensors. Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A ...
The other input of the op-amp is also connected to ground. This provides a low-impedance load for the photodiode, which keeps the photodiode voltage low. The photodiode is operating in photovoltaic mode with no external bias. The high gain of the op-amp keeps the photodiode current equal to the feedback current through R f. The input offset ...