Search results
Results from the WOW.Com Content Network
Cultivator was designed to cut a trench 7 feet 6 inches (2.29 m) wide and 5 feet (1.5 m) deep, and it would dispose of the spoil on banks either side of the cut trench. It could dig at 0.42 or 0.67 miles per hour (0.68 or 1.08 km/h) or travel at 3.04 miles per hour (4.89 km/h) on the surface.
A micro trencher is a "small rockwheel" specially designed for work in urban areas. It is fitted with a cutting wheel that cuts a microtrench with smaller dimensions than can be achieved with conventional trench digging equipment. Microtrench widths range from about 30 to 130 mm (1.2 to 5.1 in) with a depth of 500 mm (20 in) or less.
The MDK-2M was a Soviet Cold War era artillery tractor. It was based on the chassis of the AT-T, [1] which itself is based on the chassis and drive system from the T-54 tank.. The MDK-2M was used for rapid digging of large coverages and for drawing tank trenches, with a digging depth up to 4.7 m width, and width 3.5 - 4m.
[2] [3] [4] A punch press is used to form holes. A screw press is also known as a fly press. A stamping press is a machine press used to shape or cut metal by deforming it with a die. It generally consists of a press frame, a bolster plate, and a ram. [5] Capping presses form caps from rolls of aluminium foil at up to 660 per minute.
Western Front; Part of the European theatre of World War I: Clockwise from top left: Men of the Royal Irish Rifles, concentrated in the trench, right before going over the top on the First day on the Somme; British soldier carries a wounded comrade from the battlefield on the first day of the Somme; A young German soldier during the Battle of Ginchy; American infantry storming a German bunker ...
[citation needed] Roman legions, when in the presence of an enemy, entrenched camps nightly when on the move. [4] The Roman general Belisarius had his soldiers dig a trench as part of the Battle of Dara in 530 AD. Trench warfare was also documented during the defence of Medina in a siege known as the Battle of the Trench (627 AD).
The exit area is sized to pass the specific volume at the design condition. [1] Second, all the rotor and stator blades in an axial compressor, and impeller inducer and diffuser vanes in a centrifugal compressor, [2] [3] are angled to meet approaching air head-on at the design condition to minimize incidence losses. Incidence losses reduce the ...
Machinery's Handbook 31st Edition, 2020 "Production of Metallic Powder", Machinery's Handbook 31st Edition, 2020. Machinery's Handbook for machine shop and drafting-room; a reference book on machine design and shop practice for the mechanical engineer, draftsman, toolmaker, and machinist (the full title of the 1st edition) is a classic reference work in mechanical engineering and practical ...