Search results
Results from the WOW.Com Content Network
Ram-air intake on a Kawasaki ZX-12R. A ram-air intake is any intake design which uses the dynamic air pressure created by vehicle motion, or ram pressure, to increase the static air pressure inside of the intake manifold on an internal combustion engine, thus allowing a greater massflow through the engine and hence increasing engine power.
Ram pressure is a pressure exerted on a body moving through a fluid medium, caused by relative bulk motion of the fluid rather than random thermal motion. [1] It causes a drag force to be exerted on the body.
Ram air refers to the principle of using the airflow created by a moving object to increase ambient pressure, known as ram pressure. Often, the purpose of a ram air system is to increase an engine's power. The term "ram air" may also refer to: Parafoils, also called ram air parachutes, non-rigid airfoils inflated by wind; Ram-air intake – an ...
An airspeed indicator is a differential pressure gauge with the pressure reading expressed in units of speed, rather than pressure. The airspeed is derived from the difference between the ram air pressure from the pitot tube, or stagnation pressure, and the static pressure. The pitot tube is mounted facing forward; the static pressure is ...
Some strategies used in designing aftermarket cold air intakes are: Reworking parts of the intake that create turbulence to reduce air resistance. [2] Providing a more direct route to the air intake by eliminating muffling devices. Shortening the length of the intake. Placing the intake duct to use the ram-air effect to give positive pressure ...
(As long as the drain hole is also blocked, as the air pressure would otherwise leak out to the atmosphere.) This is caused by the pressure in the pitot system remaining constant when the atmospheric pressure (and static pressure) are decreasing. Conversely, the airspeed indicator will show a decrease in airspeed when the aircraft descends.
The pitot tube may become blocked, because of insects, dirt or failure to remove the pitot cover. A blockage will prevent ram air from entering the system. If the pitot opening is blocked, but the drain hole is open, the system pressure will drop to ambient pressure, and the ASI pointer will drop to a zero reading. If both the opening and drain ...
The way they do this is during a deceleration of the vehicle when there is low absolute pressure in the intake manifold (i.e., a high vacuum present in the intake manifold relative to the outside air) the powertrain control module (PCM) will open the EGR valve and then monitor the MAP sensor's values. If the EGR is functioning properly, the ...