Ads
related to: programmable thermostat damper relay control switch kitzoro.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
After the control of air flow and temperature was standardized, the use of electromechanical relays in ladder logic to switch dampers became standardized. Eventually, the relays became electronic switches, as transistors eventually could handle greater current loads. By 1985, pneumatic controls could no longer compete with this new technology ...
The control air typically is maintained on "mains" at 15-18 psi (although usually operable up to 20 psi). Pneumatic thermostats typically provide output/ branch/ post-restrictor (for single-pipe operation) pressures of 3-15 psi which is piped to the end device (valve/ damper actuator/ pneumatic-electric switch, etc.). [11]
The gas savings for manual thermostat replacements (10% per thermostat) was found to be larger than for programmable thermostat replacements (8% per thermostat). The difference in electricity savings between homes whose prior equipment was a manual thermostat or programmable thermostat was found to be minimal. [1]
A non-rechargeable battery always powers the thermostat. To limit the amount of power drawn from the battery, such thermostats use an impulse relay that does not require the continuous application of power to the relay's coil. These thermostats can be used on millivolt circuits, as well as conventional 24 VAC circuits.
This damper can switch the electrical power to control additional "slave" dampers, minimizing the electrical load on the damper's control circuitry and power transformer. A zone damper (also known as a Volume Control Damper or VCD) is a specific type of damper used to control the flow of air in an HVAC heating or cooling system. In order to ...
The term programmable communicating thermostat (PCT) is used by the California Energy Commission to describe programmable thermostats that can receive information wirelessly. The first version of the PCT introduced in the 2008 building standards proceeding also required that PCTs allow temperature control during emergency events to avoid blackouts.
Ads
related to: programmable thermostat damper relay control switch kitzoro.com has been visited by 1M+ users in the past month