Search results
Results from the WOW.Com Content Network
A simple power entry module, the rectangular device below a red power switch in the photograph. This example consists of an IEC 60320 C14 inlet connector and fuse holder. The fuse is protected by a sliding plastic cover, which requires the power lead to be removed before it can be opened.
The primary purpose of a powerline sensor is to measure current, however, some sensors can either directly measure or derive other data such as: Conductor temperature; Ambient temperature; Inclination or the amount of line sagging; Wind movement; Electric fields; Power Generation; Distribution and Consumption of electricity
A remote terminal unit (RTU) is a microprocessor-controlled electronic device that interfaces objects in the physical world to a distributed control system or SCADA (supervisory control and data acquisition) system by transmitting telemetry data to a master system, and by using messages from the master supervisory system to control connected objects. [1]
In a diesel, the sensor will control the fuel injection. The sensor output may also be related to other sensor data including the cam position to derive the current combustion cycle, this is very important for the starting of a four-stroke engine. Sometimes, the sensor may become burnt or worn out - or just die of old age at high mileage.
A PTO at the rear end of a farm tractor A PTO (in the box at the bottom) in the center of the three-point hitch of a tractor. A power take-off or power takeoff (PTO) is one of several methods for taking power from a power source, such as a running engine, and transmitting it to an application such as an attached implement or separate machine.
The SAE J2716 SENT (Single Edge Nibble Transmission) protocol [1] is a point-to-point scheme for transmitting signal values from a sensor to a vehicle controller. It is intended to allow for transmission of high resolution data with a low system cost.
The Wärtsilä RT-flex96C is a two-stroke turbocharged low-speed diesel engine designed by the Finnish manufacturer Wärtsilä.It is designed for large container ships that run on heavy fuel oil.
MAP sensor data can be converted to air mass data by using a second variable coming from an IAT Sensor (intake air temperature sensor). This is called the speed-density method. Engine speed (RPM) is also used to determine where on a look up table to determine fuelling, hence speed-density (engine speed / air density).