Search results
Results from the WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks.The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
A network and wildcard mask combination of 1.1.1.1 0.0.0.0 would match an interface configured exactly with 1.1.1.1 only, and nothing else. Wildcard masks are used in situations where subnet masks may not apply. For example, when two affected hosts fall in different subnets, the use of a wildcard mask will group them together.
This is a list of the IP protocol numbers found in the field Protocol of the IPv4 header and the Next Header field of the IPv6 header.It is an identifier for the encapsulated protocol and determines the layout of the data that immediately follows the header.
Enhanced Interior Gateway Routing Protocol (EIGRP) is an advanced distance-vector routing protocol that is used on a computer network for automating routing decisions and configuration. The protocol was designed by Cisco Systems as a proprietary protocol, available only on Cisco routers.
In computer network research, network simulation is a technique whereby a software program replicates the behavior of a real network. This is achieved by calculating the interactions between the different network entities such as routers, switches, nodes, access points, links, etc. [1] Most simulators use discrete event simulation in which the modeling of systems in which state variables ...
The Cisco Internetwork Operating System enables network administrators to modify the distance by changing the distance value in sub-router configuration mode. In the example below, RIP's administrative distance is changed to 89 so that it used in preference to OSPF.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network. A remote network is a network that can only be reached by sending the packet to another router. Routing table entries to remote networks may be either dynamic or static.