Search results
Results from the WOW.Com Content Network
The TH400 was phased out for the 1980 models, when the A-727 replaced the TH-400 as the only automatic transmission option for both the SJ Wagoneer/Cherokee wagons and the J-10/J-20 trucks. Internally similar to the Chrysler A-727, the case was one-piece, cast with an AMC pattern bellhousing (not interchangeable with a Chrysler pattern A-727).
Gear shift lever on a motorcycle (above the toe of the rider's boot) A sequential manual transmission is unsynchronized, and allows the driver to select either the next gear (e.g. shifting from first gear to second gear) or the previous gear (e.g., shifting from third gear to second gear), operated either via electronic paddle-shifters mounted behind the steering wheel or with a sequential ...
Manual – the driver has to perform each gear change using a manually operated clutch; Automatic – once placed in drive (or any other 'automatic' selector position), it automatically selects the gear ratio dependent on engine speed and load; Basically there are two types of engine installation:
The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...
A manual transmission (MT), also known as manual gearbox, standard transmission (in Canada, the United Kingdom and the United States), or stick shift (in the United States), is a multi-speed motor vehicle transmission system where gear changes require the driver to manually select the gears by operating a gear stick and clutch (which is usually ...
The transmission control unit (TCU) in older automobiles with a clutchless manual transmission (without a clutch pedal) typically consists of an electrical switch connected to the gearshift, that is activated whenever the internal transmission control unit senses driver touching the gearshift to switch gears, which then primes a sensor or ...
The name refers to the ability of the disk to flex along its main axis to account for gear changes and/or small misalignments as rotational speeds change. [2] Flexplates are generally much thinner and lighter than flywheels not only because of the required flexibility, but also due to the smoother coupling action of the torque converter [3] and the elimination of the clutch surface.
manual 5-speed transmission instead of six speeds, various bed heights including reduced tire dimensions on the (driven) rear axle for the low bed variants. The Canter Guts is powered either by a Nissan ZD30DDTI diesel engine having 81 kW at 2800 rpm and 276 Nm at 1260-2800 rpm or by a petrol engine with a manual 5-speed transmission with ...