Search results
Results from the WOW.Com Content Network
The Janka hardness test results tabulated below followed ASTM D 1037-12 testing methods. Lumber stocks tested range from 1" to 2" (25–50 mm) thick. The tabulated Janka hardness numbers are an average. There is a standard deviation associated with each species, but these values are not given. [citation needed] No testing was done on actual ...
Applications for superaustenitic stainless steel alloy AL-6XN include chemical processing, oil and gas, medical – sterilization and power generation [3] with specific applications identified in desalination, water piping systems. transformer cases in marine environments, food processing equipment, FGD scrubbers, reverse osmosis, and heat exchangers.
Pitting resistance equivalent number (PREN) is a predictive measurement of a stainless steel's resistance to localized pitting corrosion based on its chemical composition. In general: the higher PREN-value, the more resistant is the stainless steel to localized pitting corrosion by chloride .
The hardness of abrasion resistant steel is determined by a Brinell hardness test. This test uses a small steel ball to inflict force on a material. The indentation created by the steel ball is then measured and used to calculate Brinell hardness number (BHN). [3]
The longer it takes, the higher the viscosity and thus the higher the SAE code. Larger numbers are thicker. J300 specifies a viscosity range for each non-winter grade, with higher grade numbers corresponding to higher viscosities. In addition, a minimum viscosity measured at a high temperature and high-shear rate (HTHS, ASTM D4683) is also ...
It is determined from the slope of a stress-strain curve produced by a flexural test (such as the ASTM D790), and uses units of force per area. [2] The flexural modulus defined using the 2-point (cantilever) and 3-point bend tests assumes a linear stress strain response. [3] Flexural modulus measurement
A diametral compression test involves applying a stress load or force to the point where a material object is split in half (down the diameter of the object). [1] This test indirectly measures the tensile property of a material object, as the molecules of the material are pushed apart in opposite directions, similar to what happens to molecules in a direct tensile strength test.
ASTM A992 steel is a structural steel alloy often used in the US for steel wide-flange and I beams. Like other carbon steels, the density of ASTM A992 steel is approximately 7850 kg/m 3 (0.2836 lb/in 3). ASTM A992 steel has the following minimum mechanical properties, according to ASTM specification A992/A992M.