enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Serial digital interface - Wikipedia

    en.wikipedia.org/wiki/Serial_digital_interface

    The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...

  3. List of video connectors - Wikipedia

    en.wikipedia.org/wiki/List_of_video_connectors

    Generally use coaxial cable types such as RG-6 and RG-59 (except for twin-lead). Belling-Lee/IEC 169-2 connector TV aerial plug (a.k.a. antenna plug) Television antenna connection for most video devices outside North America. Used by early home computers and game consoles to connect them to TVs because of the lack of any other connector.

  4. SDI-12 - Wikipedia

    en.wikipedia.org/wiki/SDI-12

    SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.

  5. Audio and video interfaces and connectors - Wikipedia

    en.wikipedia.org/wiki/Audio_and_video_interfaces...

    F connectors, also known as RF connectors, were the standard analog connector of the analog era in the Americas, used primarily with coaxial cable (RG-59 and RG-6), and have been repurposed for generic digital data connections. SCART was the standard connector of the analog era in Europe. S-Video was an improvement over the F connector.

  6. List of RF connector types - Wikipedia

    en.wikipedia.org/wiki/List_of_RF_connector_types

    A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...

  7. SMPTE 259M - Wikipedia

    en.wikipedia.org/wiki/SMPTE_259M

    SMPTE 259M is a standard published by SMPTE which "describes a 10-bit serial digital interface operating at 143/270/360 Mb/s." [1]The goal of SMPTE 259M is to define a serial digital interface (based on a coaxial cable), called SDI or SD-SDI.

  8. SMPTE 292 - Wikipedia

    en.wikipedia.org/wiki/SMPTE_292

    SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...

  9. SDI - Wikipedia

    en.wikipedia.org/wiki/SDI

    Serial digital interface for sending video signals over coaxial cable; Single document interface, a style of graphical user interface; Software-defined infrastructure, with no human intervention; Spatial data infrastructure; Standard Disk Interconnect, a DEC standard; Statistical Design Institute's SDI Tools for Microsoft Excel