Search results
Results from the WOW.Com Content Network
The various serial digital interface standards all use (one or more) coaxial cables with BNC connectors, with a nominal impedance of 75 ohms. This is the same type of cable used in analog composite video setups, which potentially makes for easier "drop in" equipment upgrades (though may be necessary for long runs at the higher bitrates for older oxidising or lower grade of cable to replaced ...
Serial digital interface (SDI) and HD-SDI. CoaXPress; 75 Ω for video signal (SDI and CoaXPress) on, for example, RG59 and RG6. 50 Ω for data link, like Ethernet on RG58. 93 Ω on RG62. 50 Ω (white/bottom row) and 75 Ω C connectors (red/top row) C connector (Concelman connector) General Radio 874 connectors GR connector (General Radio connector)
Often designated by the CVBS acronym, meaning "Color, Video, Blank and Sync". RCA jack, normally yellow (often accompanied with red and white for right and left audio channels respectively) S-Video (Separate Video). Carries standard definition video and does not carry audio on the same cable. Mini-DIN 4-pin Component. In popular use, it refers ...
SMPTE 292 is a digital video transmission line standard published by the Society of Motion Picture and Television Engineers (SMPTE). This technical standard is usually referred to as HD-SDI; it is part of a family of standards that define a serial digital interface based on a coaxial cable, intended to be used for transport of uncompressed digital video and audio in a television studio ...
Keyboard and mouse cables and ports are almost invariably serial—such as PS/2 port, Apple Desktop Bus and USB. The cables that carry digital video are also mostly serial—such as coax cable plugged into a HD-SDI port, a webcam plugged into a USB port or FireWire port , Ethernet cable connecting an IP camera to a Power over Ethernet port, FPD ...
SDI-12 (Serial Digital Interface at 1200 baud) is an asynchronous serial communications protocol for intelligent sensors that monitor environment data. These instruments are typically low-power (12 volts), are used at remote locations, and usually communicate with a data logger or other data acquisition device.
[12] Chip or FPGA based designs sometimes use SPI to communicate between internal components; on-chip real estate can be as costly as its on-board cousin. And for high-performance systems, FPGAs sometimes use SPI to interface as a sub to a host, as a main to sensors, or for flash memory used to bootstrap if they are SRAM-based.
Serial digital interface for sending video signals over coaxial cable; Single document interface, a style of graphical user interface; Software-defined infrastructure, with no human intervention; Spatial data infrastructure; Standard Disk Interconnect, a DEC standard; Statistical Design Institute's SDI Tools for Microsoft Excel