enow.com Web Search

  1. Ads

    related to: calculate pull up resistor

Search results

  1. Results from the WOW.Com Content Network
  2. Pull-up resistor - Wikipedia

    en.wikipedia.org/wiki/Pull-up_resistor

    A resistor with relatively high resistance is called a "weak" pull-up or pull-down; when the circuit is open, it will pull the output high or low more slowly, but will draw less current. This current, which is essentially wasted energy, only flows when the switch is closed, and technically for a brief period after it is opened until the charge ...

  3. Depletion-load NMOS logic - Wikipedia

    en.wikipedia.org/wiki/Depletion-load_NMOS_logic

    A resistor (with the current simply proportional to the voltage) would be better, and a current source (with the current fixed, independent of voltage) better yet. A depletion-mode device with gate tied to the opposite supply rail is a much better load than an enhancement-mode device, acting somewhere between a resistor and a current source.

  4. Open collector - Wikipedia

    en.wikipedia.org/wiki/Open_collector

    The output is usually connected to an external pull-up resistor, which pulls the output voltage to the resistor's supply voltage when the transistor is off. For PNP open collector outputs, the emitter of the PNP transistor is internally connected to the positive voltage rail , so the collector outputs a high voltage when the transistor is on or ...

  5. 1-Wire - Wikipedia

    en.wikipedia.org/wiki/1-Wire

    A 1-Wire network is a single open drain wire with a single pull-up resistor. The pull-up resistor pulls the wire up to 3 or 5 volts. The master device and all the slaves each have a single open-drain connection to drive the wire, and a way to sense the state of the wire.

  6. Talk:Pull-up resistor - Wikipedia

    en.wikipedia.org/wiki/Talk:Pull-up_resistor

    The voltage drop across any resistor depends on the current flowing; in a circuit, currents can change and consequently the voltages at specific points in that circuit may go up at one end of what is called a pull-up resistor, or down at one end of what is called a pull-down resistor.

  7. 555 timer IC - Wikipedia

    en.wikipedia.org/wiki/555_timer_IC

    A 555 timer can act as an active-low SR latch (though without an inverted Q output) with two outputs: output pin is a push-pull output, discharge pin is an open-collector output (requires a pull-up resistor). For the schematic on the right, a Reset input signal connects to the RESET pin and connecting a Set input signal to the TR pin.

  8. E series of preferred numbers - Wikipedia

    en.wikipedia.org/wiki/E_series_of_preferred_numbers

    Two decades of E12 values, which would give resistor values of 1 Ω to 82 Ω The E series is a system of preferred numbers (also called preferred values) derived for use in electronic components . It consists of the E3 , E6 , E12 , E24 , E48 , E96 and E192 series, [ 1 ] where the number after the 'E' designates the quantity of logarithmic value ...

  9. Pull-up resistors - Wikipedia

    en.wikipedia.org/?title=Pull-up_resistors&...

    From Wikipedia, the free encyclopedia. Redirect page

  1. Ads

    related to: calculate pull up resistor