enow.com Web Search

  1. Ad

    related to: ported vs sealed enclosure motor control valve

Search results

  1. Results from the WOW.Com Content Network
  2. Crankcase ventilation system - Wikipedia

    en.wikipedia.org/wiki/Crankcase_ventilation_system

    The crankcase air outlet, where the PCV valve is located, is generally placed as far as possible from the crankcase breather. For example, the breather and outlet are frequently on opposite valve covers on a V engine, or on opposite ends of the valve cover on an inline engine. The PCV valve is often, but not always, placed at the valve cover ...

  3. Diaphragm valve - Wikipedia

    en.wikipedia.org/wiki/Diaphragm_valve

    Diaphragm valves can be controlled by various types of actuators e.g. manual, pneumatic, hydraulic, electric etc. The most common diaphragm valves use pneumatic actuators; in this type of valve, air pressure is applied through a pilot valve into the actuator which in turn raises the diaphragm and opens the valve. This type of valve is one of ...

  4. Cylinder head porting - Wikipedia

    en.wikipedia.org/wiki/Cylinder_head_porting

    This graph shows the pressure taken from the valve end (blue line) and the runner entrance(red line) of an engine with a 7-inch (180 mm) port/runner and running at 4500 rpm. Highlighted are two waves, a suction wave and a valve closing wave, seen and the valve end and runner entrance showing the signal delay.

  5. Sleeve valve - Wikipedia

    en.wikipedia.org/wiki/Sleeve_valve

    A sleeve valve takes the form of one (or in the case of double sleeve valves, two) machined cylinders which fit concentrically between the piston and the cylinder block bore of an internal combustion engine having cross-flow induction/exhaust. These sleeves have inlet and exhaust ports machined in the periphery, analogous to a two-stroke motor ...

  6. Flow control valve - Wikipedia

    en.wikipedia.org/wiki/Flow_control_valve

    The most common final control element in the process control industries is the control valve. The control valve manipulates a flowing fluid, such as gas, steam, water, or chemical compounds, to compensate for the load disturbance and keep the regulated process variable as close as possible to the desired set point. [1]

  7. Rotary valve - Wikipedia

    en.wikipedia.org/wiki/Rotary_valve

    A rotary valve (also called rotary-motion valve) is a type of valve in which the rotation of a passage or passages in a transverse plug regulates the flow of liquid or gas through the attached pipes. [1] The common stopcock is the simplest form of rotary valve. Rotary valves have been applied in numerous applications, including:

  8. Two-stroke power valve system - Wikipedia

    en.wikipedia.org/wiki/Two-stroke_power_valve_system

    Within the head and cylinder of the engine, there is a chamber that is sealed by a valve. This sealed chamber is vented onto the exhaust port when the valve is open. At low RPM this valve is open, this has the effect of increasing the exhaust manifold volume and negating the power loss that would normally be apparent at low RPM with an ...

  9. Motor control center - Wikipedia

    en.wikipedia.org/wiki/Motor_control_center

    A motor control center (MCC) is an assembly to control some or all electric motors in a central location. It consists of multiple enclosed sections having a common power bus and with each section containing a combination starter, which in turn consists of motor starter , fuses or circuit breaker , and power disconnect . [ 1 ]

  1. Ad

    related to: ported vs sealed enclosure motor control valve