Search results
Results from the WOW.Com Content Network
An n-gauge diameter means that a ball of lead (density 11.34 g/cm 3 or 0.4097 lb/in 3) with that diameter has a mass equal to 1 / n part of the mass of the international avoirdupois pound (approx. 454 grams), that is, that n such lead balls could be cast from a pound weight of lead.
Having a typical internal width of 2.44 m (96 + 1 ⁄ 8 in), [89] (a gain of ~ 10 centimetres (3 + 15 ⁄ 16 in) over the ISO-usual 2.34 m (92 + 1 ⁄ 8 in), [90] gives pallet-wide containers a usable internal floor width of 2.40 m (94 + 1 ⁄ 2 in), compared to 2.00 m (78 + 3 ⁄ 4 in) in standard containers, because the extra width enables ...
Specific modulus is a materials property consisting of the elastic modulus per mass density of a material. It is also known as the stiffness to weight ratio or specific stiffness. High specific modulus materials find wide application in aerospace applications where minimum structural weight is required. The dimensional analysis yields units of ...
In descriptive statistics, the interquartile range (IQR) is a measure of statistical dispersion, which is the spread of the data. [1] The IQR may also be called the midspread, middle 50%, fourth spread, or H‑spread. It is defined as the difference between the 75th and 25th percentiles of the data. [2][3][4] To calculate the IQR, the data set ...
The solid angle of a sphere measured from any point in its interior is 4 π sr, and the solid angle subtended at the center of a cube by one of its faces is one-sixth of that, or 2 π /3 sr. Solid angles can also be measured in square degrees (1 sr = (180/ π) 2 square degrees), in square arc-minutes and square arc-seconds, or in fractions of ...
The hydraulic diameter, DH, is a commonly used term when handling flow in non-circular tubes and channels. Using this term, one can calculate many things in the same way as for a round tube. When the cross-section is uniform along the tube or channel length, it is defined as [1][2] where. P is the wetted perimeter of the cross-section.
Stress expresses the internal forces that neighbouring particles of a continuous material exert on each other, while strain is the measure of the relative deformation of the material. [3] For example, when a solid vertical bar is supporting an overhead weight , each particle in the bar pushes on the particles immediately below it.
ISO 668 – Series 1 freight containers – Classification, dimensions and ratings is an ISO international standard which nominally classifies intermodal freight shipping containers, and standardizes their sizes, measurements and weight specifications. [1] The current version of the standard is the Seventh edition (2020), which integrates ...