Ad
related to: how to calculate boiler capacity- Repair Your Water Heater
Hire a professional to repair your
water heater. Get a free estimate.
- Install a Thermostat
Hire a professional to install a
thermostat. Enter your zip to start
- Local Insulation Pros
Connect With Insulation Contractors
Fast and Free Bids
- Plumbing Professionals
Compare Local Plumbers
Who Can Get The Job Done!
- Repair Your Water Heater
Search results
Results from the WOW.Com Content Network
In thermodynamics, the thermal efficiency ( ) is a dimensionless performance measure of a device that uses thermal energy, such as an internal combustion engine, steam turbine, steam engine, boiler, furnace, refrigerator, ACs etc. For a heat engine, thermal efficiency is the ratio of the net work output to the heat input; in the case of a heat ...
The method proceeds by calculating the heat capacity rates (i.e. mass flow rate multiplied by specific heat capacity) and for the hot and cold fluids respectively. To determine the maximum possible heat transfer rate in the heat exchanger, the minimum heat capacity rate must be used, denoted as C m i n {\displaystyle \ C_{\mathrm {min} }} :
In building design, thermal mass is a property of the matter of a building that requires a flow of heat in order for it to change temperature. In scientific writing the term "heat capacity" is preferred. It is sometimes known as the thermal flywheel effect. [1] The thermal mass of heavy structural elements can be designed to work alongside a ...
Heat of combustion. The heating value (or energy value or calorific value) of a substance, usually a fuel or food (see food energy), is the amount of heat released during the combustion of a specified amount of it. The calorific value is the total energy released as heat when a substance undergoes complete combustion with oxygen under standard ...
Turndown ratio refers to the width of the operational range of a device, and is defined as the ratio of the maximum capacity to minimum capacity. For example, a device with a maximum output of 10 units and a minimum output of 2 units has a turndown ratio of 5. The term is commonly used with measurement devices and combustion plant like boilers ...
Capacity factor. The net capacity factor is the unitless ratio of actual electrical energy output over a given period of time to the theoretical maximum electrical energy output over that period. [1] The theoretical maximum energy output of a given installation is defined as that due to its continuous operation at full nameplate capacity over ...
In thermodynamics, the heat transfer coefficient or film coefficient, or film effectiveness, is the proportionality constant between the heat flux and the thermodynamic driving force for the flow of heat (i.e., the temperature difference, ΔT ). It is used in calculating the heat transfer, typically by convection or phase transition between a ...
In thermal engineering, the logarithmic mean temperature difference (LMTD) is used to determine the temperature driving force for heat transfer in flow systems, most notably in heat exchangers. The LMTD is a logarithmic average of the temperature difference between the hot and cold feeds at each end of the double pipe exchanger.
Ad
related to: how to calculate boiler capacity