enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ASTM A325 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A325

   ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]

3. ASTM A490 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A490

   ASTM A490 and ASTM A490M are ASTM International standards for heavy hex structural bolts made from alloy steel.The imperial standard is officially titled Standard Specification for Structural Bolts, Alloy Steel, Heat Treated, 150 ksi Minimum Tensile Strength, while the metric standard (M) is titled Standard Specification for High-Strength Steel Bolts, Classes 10.9 and 10.9.3, for Structural ...

4. ASTM F568M - Wikipedia

   en.wikipedia.org/wiki/ASTM_F568M

   ASTM F568M is an ASTM International standard for metric bolts, screws and studs that are used in general engineering applications. It is titled: Standard Specification for Carbon and Alloy Steel Externally Threaded Metric Fasteners. It defines mechanical properties for fasteners that range from M1.6 to 100 in diameter. The standard was ...

5. ISO 898 - Wikipedia

   en.wikipedia.org/wiki/ISO_898

   This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...

6. Screw - Wikipedia

   en.wikipedia.org/wiki/Screw

   High-strength steel bolts usually have a hexagonal head with an ISO strength rating (called property class) stamped on the head. And the absence of marking/number indicates a lower grade bolt with low strength. The property classes most often used are 5.8, 8.8, and 10.9. The number before the point is the ultimate tensile strength in MPa ...

7. Steel grades - Wikipedia

   en.wikipedia.org/wiki/Steel_grades

   High Tensile Strength Flat products: Minimum Yield Case: If followed by T then the given mechanical property is minimum tensile strength D: Flat Products for Cold Forming: Followed by C, D or X and two numbers characterising steel T: Tinmill Products: Nominal Yield Case: M: Electrical Steel: Number = 100 × specific loss in W/kg Number = 100 × ...

8. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Bolted joint in vertical section Screw joint. The distinction between a bolt and a screw is poorly defined. The academic distinction, per Machinery's Handbook, [3] is in their intended purpose: bolts are designed to pass through an unthreaded hole in a component and be fastened with the aid of a nut.

9. Anchor bolt - Wikipedia

   en.wikipedia.org/wiki/Anchor_bolt

   A cast-in-place anchor bolt. The simplest – and strongest – form of anchor bolt is cast-in-place, with its embedded end consisting of a standard hexagonal head bolt and washer, 90-bend, or some sort of forged or welded flange (see also stud welding). The last are used in concrete-steel composite structures as shear connectors. [6]