Search results
Results from the WOW.Com Content Network
Wi-Fi Direct is a Wi-Fi standard for wireless connections [1] that allows two devices to establish a direct Wi-Fi connection without an intermediary wireless access point, router, or Internet connection. Wi-Fi Direct is single-hop communication, rather than multi-hop communication like wireless ad hoc networks. The Wi-Fi Direct standard was ...
SparkFun ESP8266 Thing. The reason for the popularity of many of these boards over the earlier ESP-xx modules is the inclusion of an on-board USB-to-UART bridge (like the Silicon Labs' CP2102 or the WCH CH340G) and a Micro-USB connector, coupled with a 3.3-volt regulator to provide both power to the board and connectivity to the host (software development) computer – commonly referred to as ...
On December 30, 2013, Espressif Systems [6] began production of the ESP8266. [12] NodeMCU started on 13 Oct 2014, when Hong committed the first file of nodemcu-firmware to GitHub. [ 13 ] Two months later, the project expanded to include an open-hardware platform when developer Huang R committed the gerber file of an ESP8266 board, named devkit ...
The person at computer B issues the modem escape command. (Alternately, and more commonly, the computer B could drop the DTR, or Data Terminal Ready signal, to achieve a hangup, without needing to use +++ or ATH.) OK: The modem acknowledges it. ATH: The person at computer B issues a hang up command. NO CARRIER: OK
To connect to a Wi-Fi LAN, a computer must be equipped with a wireless network interface controller. The combination of a computer and an interface controller is called a station. Stations are identified by one or more MAC addresses. Wi-Fi nodes often operate in infrastructure mode in which all communications go through a base station.
There are two kinds of wireless gateways. The simpler kind must be connected to a DSL modem or cable modem to connect to the internet via the internet service provider (ISP). The more complex kind has a built-in modem to connect to the internet without needing another device. [2]
Some wireless routers have one or two USB ports. These can be used to connect printer or desktop or mobile external hard disk drive to be used as a shared resource on the network. [2] A USB port may also be used for connecting mobile broadband modem, [3] aside from connecting the wireless router to an Ethernet with xDSL or cable modem. A mobile ...
A wireless network interface controller may be implemented as an expansion card and connected using PCI bus or PCIe bus, or connected via USB, PC Card, ExpressCard, Mini PCIe or M.2. The low cost and ubiquity of the Wi-Fi standard means that many newer mobile computers have a wireless network interface built into the motherboard.