Search results
Results from the WOW.Com Content Network
Symbol-specific names are also used; decimal point and decimal comma refer to a dot (either baseline or middle) and comma respectively, when it is used as a decimal separator; these are the usual terms used in English, [1] [2] [3] with the aforementioned generic terms reserved for abstract usage. [4] [5]
A thousandth of an inch is a derived unit of length in a system of units using inches.Equal to 1 ⁄ 1000 of an inch, a thousandth is commonly called a thou / ˈ θ aʊ / (used for both singular and plural) or, particularly in North America, a mil (plural mils).
A fixed-point representation of a fractional number is essentially an integer that is to be implicitly multiplied by a fixed scaling factor. For example, the value 1.23 can be stored in a variable as the integer value 1230 with implicit scaling factor of 1/1000 (meaning that the last 3 decimal digits are implicitly assumed to be a decimal fraction), and the value 1 230 000 can be represented ...
99.3 is "ninety-nine point three"; or "ninety-nine and three tenths" (U.S., occasionally). In English the decimal point was originally printed in the center of the line (0·002), but with the advent of the typewriter it was placed at the bottom of the line, so that a single key could be used as a full stop/period and as a decimal point.
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths). (Decimal places for .25, .5, and .75 are shown to thousandths [.250, .500, .750], which is how machinists usually think about them ["two-fifty", "five hundred", "seven-fifty"]. Machinists generally ...
Similarly, if the final digit on the right of the decimal mark is zero—that is, if b n = 0 —it may be removed; conversely, trailing zeros may be added after the decimal mark without changing the represented number; [note 1] for example, 15 = 15.0 = 15.00 and 5.2 = 5.20 = 5.200. For representing a negative number, a minus sign is placed ...
4 / 5 Four fifths, eight tenths, [zero] point eight 0.75 3 / 4 three quarters, three fourths, seventy-five hundredths, [zero] point seven five 0.7 7 / 10 Seven tenths, [zero] point seven 0.666 666... 2 / 3 Two thirds 0.6 3 / 5 Three fifths, six tenths, [zero] point six 0.5 1 / 2 One half, five ...