Search results
Results from the WOW.Com Content Network
Until early in the 20th century, it was the unit used to measure the depth of mines (mineral extraction) in the United Kingdom. [30] Miners also use it as a unit of area equal to 6 feet square (3.34 m 2) in the plane of a vein. [2] In Britain, it can mean the quantity of wood in a pile of any length measuring 6 feet (1.8 m) square in cross ...
Depth is the depth of the hold, in feet below the main deck. The numerator yields the ship's volume expressed in cubic feet. If a "tun" is deemed to be equivalent to 100 cubic feet, then the tonnage is simply the number of such 100 cubic feet 'tun' units of volume. 100 the divisor is unitless, so tonnage would be expressed in 'ft 3 of tun'. [1]
A sailor and a man on shore, both sounding the depth with a line. Depth sounding, often simply called sounding, is measuring the depth of a body of water. Data taken from soundings are used in bathymetry to make maps of the floor of a body of water, such as the seabed topography. Soundings were traditionally shown on nautical charts in fathoms and
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [5] Common imperial units and U.S. customary units of length include: [6] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
A cable length or length of cable is a nautical unit of measure equal to one tenth of a nautical mile or approximately 100 fathoms.Owing to anachronisms and varying techniques of measurement, a cable length can be anywhere from 169 to 220 metres (185 to 241 yd), depending on the standard used.
Cable length: Length: Fathom: Length: Knot: Speed: League: Length: Nautical mile: Length: Rhumb: Angle: The angle between two successive points of the thirty-two point compass (11 degrees 15 minutes) (rare) [1] Shackle: Length: Before 1949, 12.5 fathoms; later 15 fathoms. [2] Toise: Length: Toise was also used for measures of area and volume ...
Driller's depth is always recorded, and it constitutes the primary depth system, unless it is later superseded by a more accurate measurement such as the depth from an open- or cased-hole wireline log. Driller's depth should always have 1) a unit of measurement e.g. meter or feet, 2) a datum reference e.g. rig floor.
Bathymetric charts showcase depth using a series of lines and points at equal intervals, called depth contours or isobaths (a type of contour line). A closed shape with increasingly smaller shapes inside of it can indicate an ocean trench or a seamount, or underwater mountain, depending on whether the depths increase or decrease going inward.