Search results
Results from the WOW.Com Content Network
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
Batteries Included was founded by siblings Alan Krofchick, Robbie Krofchick and Marcie Swartz in 1978 as a calculator and personal computer retail store. [2] The hand-held electronic devices they sold were always advertised as "batteries not included," so they included the batteries for free and named themselves Batteries Included. [3]
Power supply may be bad Long continuous beep tone Memory failure Steady, long beeps Power supply bad No beep Power supply bad, system not plugged in, or power not turned on No beep If everything seems to be functioning correctly there may be a problem with the 'beeper' itself. The system will normally beep one short beep. One long, two short beeps
First-generation microcomputer and home computer power supply units used a heavy step-down transformer and a linear power supply, as used, in for example, the Commodore PET introduced in 1977. The Apple II , also introduced in 1977, was noted for its switched-mode power supply , which was lighter and smaller than an equivalent linear power ...
An integrated power supply is one that shares a common printed circuit board with its load. An external power supply, AC adapter or power brick, is a power supply located in the load's AC power cord that plugs into a wall outlet; a wall wart is an external supply integrated with the outlet plug itself. These are popular in consumer electronics ...
An uninterruptible power supply (UPS) or uninterruptible power source is a type of continual power system that provides automated backup electric power to a load when the input power source or mains power fails.
As in SMBus 2.0, only seven-bit addressing is used. Some commands use the SMBus 2.0 block process calls. Either the SMBALERT# mechanism or the SMBus 2.0 host notify protocol may be used to notify the host about faults. PMBus devices are required to support a Group Protocol, where devices defer acting on commands until they receive a terminating ...