Search results
Results from the WOW.Com Content Network
The traditional typographic units are based either on non-metric units, or on odd multiples (such as 35 ⁄ 83) of a metric unit.There are no specifically metric units for this particular purpose, although there is a DIN standard sometimes used in German publishing, which measures type sizes in multiples of 0.25 mm, and proponents of the metrication of typography generally recommend the use of ...
A fire hydrant marked as 3-inch. The inch (symbol: <3 or ″) is a unit of length in the British Imperial and the United States customary systems of measurement.It is equal to 1 / 36 yard or 1 / 12 of a foot.
A ruler, depicting two customary units of length, the centimeter and the inch. A unit of length refers to any arbitrarily chosen and accepted reference standard for measurement of length. The most common units in modern use are the metric units, used in every country globally. In the United States the U.S. customary units are also in use.
A less precise definition is one pica equals 0.166 inches (4.2 mm), and one point 0.01383 inches (0.351 mm). [27] [33] It was also noticed that 83 picas is nearly equal to 35 cm, so the Type Founders Association also suggested using a 35 cm metal rod for measurements, but this was not accepted by every foundry. [27]
It has 1 ⁄ 2 in (12.7 mm) spacing between ruling lines, with a single margin drawn down the center of the page. Wide ruled (or legal ruled) paper has 11 ⁄ 32 in (8.7 mm) spacing between horizontal lines, with a vertical margin drawn about 1 + 1 ⁄ 4 inches (32 mm) from the left-hand edge of the page. It is commonly used by American ...
Volume was measured in ngogn (equal to 1000 cubic potrzebies), mass in blintz (equal to the mass of 1 ngogn of halva, which is "a form of pie [with] a specific gravity of 3.1416 and a specific heat of .31416"), and time in seven named units (decimal powers of the average earth rotation, equal to 1 "clarke").
It is 5.5 typographical points, or about 1 ⁄ 13 inch (1.94 mm). It can refer either to the height of a line of type or to a font that is 5.5 points. An agate font is commonly used to display statistical data or legal notices in newspapers. It is considered to be the smallest point size that can be printed on newsprint and remain legible.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...