enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.

3. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   The hydraulic cylinders on this excavator operate the machine's linkages. Hydraulic cylinders in a hot press of a particle board machine. A hydraulic cylinder (also called a linear hydraulic motor) is a mechanical actuator that is used to give a unidirectional force through a unidirectional stroke.

4. Telescopic cylinder - Wikipedia

   en.wikipedia.org/wiki/Telescopic_cylinder

   Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.

5. Boss (engineering) - Wikipedia

   en.wikipedia.org/wiki/Boss_(engineering)

   Two bosses in the form of cylinders on a mechanical part. The cylinder to the right is filleted near its base. In engineering, a boss is a protruding feature on a workpiece. [1] A common use for a boss is to locate one object within a pocket or hole of another object.

6. Master cylinder - Wikipedia

   en.wikipedia.org/wiki/Master_cylinder

   The most common vehicle uses of master cylinders are in brake and clutch systems.. In brake systems, the operated devices are cylinders inside brake calipers and/or drum brakes; these cylinders may be called wheel cylinders or slave cylinders, and they push the brake pads towards a surface that rotates with the wheel (this surface is typically either a drum or a disc, a.k.a. a rotor) until the ...

7. Position-sensing hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Position-sensing_hydraulic...

   The machining and additional production steps associated with “gun drilling” the piston rod can add cost to the finished cylinder. Magnetostrictive LDTs provide extremely high accuracy, down to one micron. [3] Hydraulic cylinder with a Hall effect sensor mounted along its barrel to sense position of a magnetic piston inside. The sensor is ...

8. Axial piston pump - Wikipedia

   en.wikipedia.org/wiki/Axial_piston_pump

   Cutaway side-view diagram of an axial piston pump 3-D rendering of an axial piston pump with the parts labeled Animation of an axial piston pump in operation. An axial piston pump has a number of pistons (usually an odd number) arranged in a circular array within a housing which is commonly referred to as a cylinder block, rotor or barrel.

9. Vehicle registration plates of Washington, D.C. - Wikipedia

   en.wikipedia.org/wiki/Vehicle_registration...

   In 1956, the United States, Canada, and Mexico came to an agreement with the American Association of Motor Vehicle Administrators, the Automobile Manufacturers Association and the National Safety Council that standardized the size for license plates for vehicles (except those for motorcycles) at 6 inches (15 cm) in height by 12 inches (30 cm) in width, with standardized mounting holes. [2]