Search results
Results from the WOW.Com Content Network
Examples of adapters include one end BSP threaded with the other NPT threaded, and one end threaded with the other a plain socket for brazing. A coupling whose ends use the same connection method but are of different sizes is called a reducing coupling or reducer. An example is a 3/4" NPT to 1/2" NPT coupling.
Copper fittings for soldered joints Pipe fittings: 1) Copper (solder); 2) Iron or brass (threaded); 3) Brass (compression); 4) Brass (compression to solder); 5) Brass adapters PVC fittings. A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube ...
Eccentric reducers are used at the suction side of pumps to ensure air does not accumulate in the pipe. The gradual accumulation of air in a concentric reducer could result in a large bubble that could eventually cause the pump to stall or cause cavitation when drawn into the pump. Eccentric reducers exhibit a unique design with one side having ...
A typical exhaust system. The parts' names translate as follows: Krümmer: manifold (in this case, the exhaust manifold); Hosenrohr: downpipe; Katalysator: catalytic converter; Mittelschalldämpfer: middle silencer (or center muffler); Vorschalldämpfer: front silencer (or pre-muffler); Nachschalldämpfer: rear silencer (or main muffler); Endrohr: tailpipe.
BMX 3-Piece bottom brackets typically use a spindle either 19 mm or 19.05 mm (3/4″), 22 mm or 22.2 mm (7/8″), or 24 mm in diameter. The majority of newer or Asian parts are made to metric round numbers, and mixes of metric and non-metric (e.g. 19 mm and 19.05 mm) spindles and bearings may not be compatible, and can result in stuck parts.
There are a number of sizes listed below that appear to be quite similar, and while the tolerances of these connectors are typically indicated as ±0.05 or ±0.03 mm by the manufacturers, there is still ambiguity as to whether two sizes differing by only 0.05 mm (or where the specification is only given to the nearest 0.10 mm) warrants listing ...
For either standard taper joints or ball-and-socket joints, inner and outer joints with the same numbers are made to fit together. When the joint sizes are different, ground glass adapters may be available (or made) to place in between to connect them. Special clips or pinch clamps may be placed around the joints to hold them in place.
The 8×68mm S case has functioned as the parent case for the .375 Hölderlin (9.5×68mm), which is essentially a 9.53 mm (.375 caliber) necked-up version of the 8×68mm S. The wildcat status of the .375 Hölderlin ended in 2007 when it got C.I.P. certified and became an officially registered and sanctioned under the 375 Hölderlin designation ...