Search results
Results from the WOW.Com Content Network
Barcol hardness is measured on a scale from 0 to 100 with the typical range being between 50B and 90B. A measurement of 60B is roughly equivalent to a Shore hardness of 80D or a Rockwell hardness M100. [4] [6] As defined in ASTM D 2583 the scale divisions from 0-100 should each indicate a depth of 0.0076 mm or the equivalent 0.0003 inches. [7]
Another Neo-Hookean linear relation between the ASTM D2240 hardness value and material elastic modulus has the form [10] =, = { < <, + < <, where is the ASTM D2240 type A hardness, is the ASTM D2240 type D hardness, and is the Young's modulus in MPa.
A number of states in the United States have adopted their own test methods but they are based on ASTM methods. [3] Although there are similarities with the method it is not the same as an acid value. ASTM D2073 - This is a potentiometric method. [4] ASTM D2074-07; ASTM D2896 - potentiometric method with perchloric acid. [5] ASTM D6979-03
† Also called a Brale indenter, is made with a conical diamond of 120° ± 0.35° included angle and a tip radius of 0.200 ± 0.010 mm. § The Rockwell number precedes the scale abbreviations (e.g., 60 HRC), except for the "Superficial scales" where they follow the abbreviations, separated by a ‘-’ (e.g., 30N-25).
ASTM (2003). C 131–03. Standard Test Method for Resistance to Degradation of Small-Size Coarse Aggregate by Abrasion and Impact in the Los Angeles Machine. ASTM International. Lavin, P. (2003). Asphalt Pavements: A Practical Guide to Design, Production and Maintenance for Engineers and Architects. CRC Press. ISBN 978-0-203-45329-2.
Common greases are in the range 1 through 3. Those with a NLGI No. of 000 to 1 are used in low viscosity applications. Examples include enclosed gear drives operating at low speeds and open gearing. Grades 0, 1 and 2 are used in highly loaded gearing. Grades 1 through 4 are often used in rolling contact bearings. Greases with a higher number ...
The Brinell hardness is designated by the most commonly used test standards (ASTM E10-14 [2] and ISO 6506–1:2005) as HBW (H from hardness, B from brinell and W from the material of the indenter, tungsten (wolfram) carbide). In former standards HB or HBS were used to refer to measurements made with steel indenters.
According to ASTM A370, [12] the standard specimen size for Charpy impact testing is 10 mm × 10 mm × 55 mm. Subsize specimen sizes are: 10 mm × 7.5 mm × 55 mm, 10 mm × 6.7 mm × 55 mm, 10 mm × 5 mm × 55 mm, 10 mm × 3.3 mm × 55 mm, 10 mm × 2.5 mm × 55 mm. Details of specimens as per ASTM A370 (Standard Test Method and Definitions for ...