enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Automatic center punch - Wikipedia

   en.wikipedia.org/wiki/Automatic_center_punch

   The Adell and Starrett mechanism uses a sliding block crosswise through the hammer rather than an intermediate pin. The hammer has a hole through its center that the top of the punch sits in, and holds the top of the punch centered. The sliding block has a hole through it that, when reset, is misaligned with the hole through the hammer.

3. Hole punch - Wikipedia

   en.wikipedia.org/wiki/Hole_punch

   A hole punch, also known as hole puncher, or paper puncher, is an office tool that is used to create holes in sheets of paper, often for the purpose of collecting the sheets in a binder or folder (such collected sheets are called loose leaves). A hole punch can also refer to similar tools for other materials, such as leather, cloth, or sheets ...

4. Punching - Wikipedia

   en.wikipedia.org/wiki/Punching

   Punching is a forming process that uses a punch press to force a tool, called a punch, through the workpiece to create a hole via shearing. Punching is applicable to a wide variety of materials that come in sheet form, including sheet metal, paper, vulcanized fibre and some forms of plastic sheet. The punch often passes through the work into a ...

5. Punching machine - Wikipedia

   en.wikipedia.org/wiki/Punching_Machine

   Quick change tool system, plug and punch (left: die; front: punch, split punch retainer; back: tool body; right: punch guide) The linear tool carrier (y-axis) has several stations that hold the punching tools and one cutting tool. Especially for flexibility and efficient processing are set up times a crucial cost factor. Downtimes should be ...

6. Punch (tool) - Wikipedia

   en.wikipedia.org/wiki/Punch_(tool)

   A punch is a tool used to indent or create a hole through a hard surface. They usually consist of a hard metal rod with a narrow tip at one end and a broad flat "butt" at the other. When used, the narrower end is pointed against a target surface and the broad end is struck with a hammer or mallet , causing the blunt force of the blow to be ...

7. Types of press tools - Wikipedia

   en.wikipedia.org/wiki/Types_of_press_tools

   The compound tool differs from progressive and stage tools by the arrangement of the punch and die. It is an inverted tool where blanking and piercing takes place in a single stage and also the blanking punch will act as the piercing die. That means punch will be to the bottom side of the tool and piercing punches to top side of the tool.