Search results
Results from the WOW.Com Content Network
Hot wire anemometers use a fine wire (on the order of several micrometres) electrically heated to some temperature above the ambient. Air flowing past the wire cools the wire. As the electrical resistance of most metals is dependent upon the temperature of the metal ( tungsten is a popular choice for hot-wires), a relationship can be obtained ...
A Langmuir–Taylor detector, also called surface ionization detector or hot wire detector, is a kind of ionization detector used in mass spectrometry, developed by John Taylor [1] based on the work of Irving Langmuir and K. H. Kingdon.
The hot film MAF sensor works somewhat similar to the hot wire MAF sensor, but instead it usually outputs a frequency signal. This sensor uses a hot film-grid instead of a hot wire. [3] It is commonly found in late 1980s and early 1990s fuel-injected vehicles. The output frequency is directly proportional to the air mass entering the engine.
Particle image velocimetry (PIV) is a non-intrusive optical flow measurement technique used to study fluid flow patterns and velocities. PIV has found widespread applications in various fields of science and engineering, including aerodynamics, combustion, oceanography, and biofluids.
Hot-wiring, a method of starting a car with no key; Hot-wire foam cutter, a tool used to cut foam and polystyrene; Hot wire (electricity), a wire conductor with non-zero potential in electric power distribution; Hot-wire anemometer, an electrical device for measuring the speed of airflow
NMEA 0183 is a combined electrical and data specification for communication between marine electronics such as echo sounder, sonars, anemometer, gyrocompass, autopilot, GPS receivers and many other types of instruments. It has been defined and is controlled by the National Marine Electronics Association (NMEA).
A hot-wire ammeter. In a hot-wire ammeter, a current passes through a wire which expands as it heats. Although these instruments have slow response time and low accuracy, they were sometimes used in measuring radio-frequency current. [4] These also measure true RMS for an applied AC.
The transient hot wire method has advantage over the other thermal conductivity methods, since there is a fully developed theory and there is no calibration or single-point calibration. Furthermore, because of the very small measuring time (1 s) there is no convection present in the measurements and only the thermal conductivity of the fluid is ...