Ads
related to: do stepper motors need encoders to start engine power plant
Search results
Results from the WOW.Com Content Network
A stepper motor, also known as step motor or stepping motor, [1] is a brushless DC electric motor that rotates in a series of small and discrete angular steps. [2] Stepper motors can be set to any given step position without needing a position sensor for feedback. The step position can be rapidly increased or decreased to create continuous ...
An engine power plant is a power station in which power comes from the combination of a reciprocating engine [1] and an alternator. Thanks to very short start-up time, [ 2 ] Engine power plants can provide full output within few minutes ( high flexibility ) and ensure load balancing.
The grey/green cylinder is the brush-type DC motor. The black section at the bottom contains the planetary reduction gear, and the black object on top of the motor is the optical rotary encoder for position feedback. Small R/C servo mechanism. 1. electric motor 2. position feedback potentiometer 3. reduction gear 4. actuator arm
An absolute encoder maintains position information when power is removed from the encoder. [5] The position of the encoder is available immediately on applying power. The relationship between the encoder value and the physical position of the controlled machinery is set at assembly; the system does not need to return to a calibration point to maintain position accuracy.
The efficiency of a conventional steam–electric power plant, defined as energy produced by the plant divided by the heating value of the fuel consumed by it, is typically 33 to 48%, limited as all heat engines are by the laws of thermodynamics (See: Carnot cycle). The rest of the energy must leave the plant in the form of heat.
A servomotor is a packaged of several components: a motor (usually electric, although fluid power motors may also be used), a gear train to reduce the many rotations of the motor to a higher torque rotation, a position encoder that identifies the position of the output shaft and an inbuilt control system. The input control signal to the servo ...
Absolute encoders can determine their position at power-on but are more complicated and expensive. Incremental encoders are simpler, cheaper, and work at faster speeds. Incremental systems, like stepper motors, often combine their inherent ability to measure intervals of rotation with a simple zero-position sensor to set their position at start-up.
The switched reluctance motor (SRM) is a type of reluctance motor. Unlike brushed DC motors , power is delivered to windings in the stator (case) rather than the rotor . This simplifies mechanical design because power does not have to be delivered to the moving rotor, which eliminates the need for a commutator .
Ads
related to: do stepper motors need encoders to start engine power plant