Search results
Results from the WOW.Com Content Network
The sling is not intended as a carrying aid, but is used to steady the rifle. For a right-handed shooter, the sling attaches to the top of the left arm, and clips onto the forend of the rifle. The left arm is wrapped under the sling. The sling with upper and lower arm form three sides of a triangle that provide a steady support for the rifle.
A rail system mounted on top of a SIG SG 550 A dovetail rail on a rifle receiver for mounting a sight. A rail integration system (RIS; also called a rail accessory system (RAS), rail interface system, rail system, mount, base, gun rail, or simply a rail [1]) is a generic term for any standardized attachment system for mounting firearm accessories via bar-like straight brackets (i.e. "rails ...
The sabot component in projectile design is the relatively thin, tough and deformable seal known as a driving band or obturation ring needed to trap propellant gases behind a projectile, and also keep the projectile centered in the barrel, when the outer shell of the projectile is only slightly smaller in diameter than the caliber of the barrel ...
In modern dropping block, break-action (e.g. double-barrel shotguns) and revolver firearms, the extractor is a protrusible piece with flanges on the barrel/cylinder side, which pushes rearwards on the casing's rim and slides it out of the chambers. Some such extractors can push hard and far enough that they completely clear the cases out of the ...
Near the front of the forearm there is often an underside sling swivel stud and sometimes also a barrel-band to secure the forearm to the barrel (as seen in the photo). [1] [2] Some forearms are equipped with additional heat shields to protect the user from heat radiating from the barrel when the firearm is fired.
Since shotgun shells are all straight walled, a change in chambering means a change in diameter of the shell. However, since subgauge inserts are designed to be used with shot, not slugs, the shotgun's barrel can continue to be used, with little or no impact on patterning. [ 7 ]
A break action is a type of firearm where the barrel(s) are hinged and can be "broken open" to expose the breech. Multi-barrel break action firearms are usually subdivided into over-and-under or side-by-side configurations for two barrel configurations or "combination gun" when mixed rifle and shotgun barrels are used.
For double-barreled guns that use one shotgun barrel and one rifle barrel, see combination gun. Double action revolver: A revolver whose trigger performs two actions, firing the round, and cocking the hammer. Double rifle: A rifle that has two barrels, usually of the same caliber. Like shotguns, they are configured either in over-and-under or ...