Search results
Results from the WOW.Com Content Network
Channel or C section girts bolted to plate cleats welded to a portal column in an industrial building. In architecture or structural engineering, a girt, also known as a sheeting rail, is a horizontal structural member in a framed wall. Girts provide lateral support to the wall panel, primarily to resist wind loads. [citation needed]
Wall framing in house construction includes the vertical and horizontal members of exterior walls and interior partitions, both of bearing walls and non-bearing walls. . These stick members, referred to as studs, wall plates and lintels (sometimes called headers), serve as a nailing base for all covering material and support the upper floor platforms, which provide the lateral strength along a
Timber framing is a general term for building with wooden posts and beams. The term post is the namesake of other general names for timber framing such as post-and-beam, post-and-girt construction and more specific types of timber framing such as Post and lintel, post-frame, post in ground, and ridge-post construction.
A bent in American English is a transverse rigid frame (or similar structures such as three-hinged arches).Historically, bents were a common way of making a timber frame; they are still often used for such, and are also seen in small steel-frame buildings, where the term portal frame is more commonly used.
Poles, from which these buildings get their name, are natural shaped or round wooden timbers 4 to 12 inches (100 to 300 mm) in diameter. [4] The structural frame of a pole building is made of tree trunks, utility poles, engineered lumber or chemically pressure-treated squared timbers which may be buried in the ground or anchored to a concrete slab.
Steel frame structure Rectangular steel frame, or "perimeter frame" of the Willis building (at right) contrasted against the diagrid frame at 30 St Mary Axe (at center), in London. Steel frame is a building technique with a " skeleton frame" of vertical steel columns and horizontal I-beams , constructed in a rectangular grid to support the ...
In steel construction, the term purlin typically refers to roof framing members that span parallel to the building eave, [5] and support the roof decking or sheeting. The purlins are in turn supported by rafters or walls. Purlins are most commonly used in Steel Framed Building Systems, where Z-shapes are utilized in a manner that allows ...
Examples of cold-formed steel that would not be considered framing includes metal roofing, roof and floor deck, composite deck, metal siding, and purlins and girts on metal buildings. Framing members are typically spaced at 16 or 24 inches on center, with spacing variations lower and higher depending upon the loads and coverings.