enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Caliber conversion device - Wikipedia

    en.wikipedia.org/wiki/Caliber_conversion_device

    A supplemental chamber or cartridge adapter is typically used for a shorter cartridge of reduced diameter. [1] A cartridge conversion sleeve may include a short barrel of reduced bore diameter. Shotgun conversion sleeves may be called subgauge inserts , subgauge tubes , or gauge reducers .

  3. Chamber pressure - Wikipedia

    en.wikipedia.org/wiki/Chamber_pressure

    Within firearms, chamber pressure is the pressure exerted by a cartridge case's outside walls on the inside of a firearm's chamber when the cartridge is fired. The SI unit for chamber pressure is the megapascal (MPa), while the American SAAMI uses the pound per square inch (psi, symbol lbf/in 2) and the European CIP uses bar (1 bar is equal to 0.1 MPa).

  4. Blank-firing adapter - Wikipedia

    en.wikipedia.org/wiki/Blank-firing_adapter

    Blank Firing Adapter attached to an M16 rifle/M203. BFAs for blowback and gas-operated firearms are relatively simple. These weapons depend on high pressures in the chamber generated by the combustion of the propellant to push the breech block to the rear, allowing another round to be chambered and fired.

  5. Tapering (firearms) - Wikipedia

    en.wikipedia.org/wiki/Tapering_(firearms)

    The American Rifle A Treatise, a Text Book, and a Book of Practical Instruction in the Use of the Rifle By Townsend Whelen · 1918. Page 134; Gun Research Declassified Visit to Mauser-Werke 2022. Page 52; The Ultimate in Rifle Accuracy By Glenn Newick · 1990; Gunsmithing at Home: Lock, Stock & Barrel - Page 79, John E. Traister · 1996

  6. Chamber (firearms) - Wikipedia

    en.wikipedia.org/wiki/Chamber_(firearms)

    A barrel chamber with pressure relief ports that allows gas to leak around the cartridge during extraction. Basically, the opposite of a fluted chamber, as it is intended for the cartridge to stick to the chamber wall making a slight delay of extraction. This requires a welded-on sleeve with an annular groove to contain the pressure. [8]

  7. Gauge (firearms) - Wikipedia

    en.wikipedia.org/wiki/Gauge_(firearms)

    The least popular sizes are the 10 gauge and the 16 gauge; while far less common than the other four gauges, they are still commercially available. [citation needed] [9] Shotguns and shells exceeding 10 gauge, such as the 8 gauge, 6 gauge, 4 gauge, and 2 gauge are historically important in the United Kingdom and elsewhere in mainland Europe ...

  8. Copper units of pressure - Wikipedia

    en.wikipedia.org/wiki/Copper_units_of_pressure

    While CUP and LUP numbers were intended to be comparable to the crushing power of a given pressure in psi (lbf/in 2), the numbers are not equivalent.Since a longer duration, lower pressure pulse can crush the cylinder as much as a shorter duration, higher pressure pulse, CUP and LUP pressures frequently register lower than actual peak pressures (as measured by a transducer) by up to 20%.

  9. Glossary of firearms terms - Wikipedia

    en.wikipedia.org/wiki/Glossary_of_firearms_terms

    Ported chamber: A barrel chamber with pressure relief ports that allows gas to leak around the cartridge during extraction. Basically the opposite of a fluted chamber as it is intended for the cartridge to stick to the chamber wall making a slight delay of extraction. This requires a welded-on sleeve with an annular groove to contain the pressure.