Search results
Results from the WOW.Com Content Network
Lime comes from Old English lim ('sticky substance, birdlime, mortar, cement, gluten'), and is related to Latin limus ('slime, mud, mire'), and linere ('to smear'). [7] Mortar is a mixture with cement and comes from Old French mortier ('builder's mortar, plaster; bowl for mixing') in the late 13th century and Latin mortarium ('mortar'). [7]
It is usually not recommended to replace more than 20% of the lime content with cement when rendering the facade, and it is a matter of contention whether adding any concrete is ever appropriate in order to maintain the benefits of lime over concrete. Lime plaster is permeable and allows for the diffusion and evaporation of moisture.
The setting speed can be increased by using impure limestone in the kiln, to form a hydraulic lime that will set on contact with water. Such a lime must be stored as a dry powder. Alternatively, a pozzolanic material such as calcined clay or brick dust may be added to the mortar mix. Addition of a pozzolanic material will make the mortar set ...
To minimize them a slowly-setting cement (CEM III, with blast furnace slags) is preferred to a quickly setting cement (CEM I: Portland cement). Pouring concrete under colder conditions (e.g., during the night, or in the winter), or using cold water and ice mixed with cooled aggregates to prepare concrete, may also contribute to minimize thermal ...
The word "cement" can be traced back to the Ancient Roman term opus caementicium, used to describe masonry resembling modern concrete that was made from crushed rock with burnt lime as binder. The volcanic ash and pulverized brick supplements that were added to the burnt lime, to obtain a hydraulic binder , were later referred to as cementum ...
The staff bead, a 1-inch dowel with approx 1 ⁄ 3 shaved off the back, is set on the external corner by the joiner on site, fastened to wooden plugs set into the brick/block seams, or to the wood frame. Plaster is run up to the staff bead and then cut back locally to the bead or "quirked" to avoid a weak feather edge where the plaster meets ...
Eminently hydraulic lime (NHL 5) is used for external work in exposed areas, such as chimneys and for floor slabs/underpinning. Eminently hydraulic lime contains clay in the range of 21% to 30%. Properties of eminently hydraulic lime are close to those of cement. Eminently hydraulic lime sets within one day after the addition of water.
The ancient Romans used a type of lime mortar that has been found to be self-healing. [8] The stratlingite crystals form along the interfacial zones of Roman concrete, binding the aggregate and mortar together and this process continued even after 2000 years and it was discovered by the geologist Marie Jackson and her colleagues in 2014.