enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Exterior insulation finishing system - Wikipedia

   en.wikipedia.org/wiki/Exterior_insulation...

   EIFS is not stucco despite often called "synthetic stucco". Traditional stucco is a centuries-old, hard, dense, thick, non-insulating material which consists of aggregate, a binder, and water. EIFS is a lightweight synthetic wall cladding that includes foam plastic insulation and thin synthetic coatings.

3. Plasterwork - Wikipedia

   en.wikipedia.org/wiki/Plasterwork

   Bastard stucco is of similar composition, but less labor is expended on it. It is laid on in two coats with a skimming float, scoured off at once, and then trowelled. Colored stucco: lime stucco may be executed in colors, the desired tints being obtained by mixing with the lime various oxides. Black and grays are obtained by using forge ashes ...

4. Direct injection expanded foam molding - Wikipedia

   en.wikipedia.org/wiki/Direct_injection_expanded...

   Direct injection expanded foam molding (also known as injection molded foam) is a manufacturing process that creates soft foam products direct from a compound into a final product. [1] This process eliminates the steps normally required for die-cutting and compression molding , because it manufactures the foam and the product, simultaneously.

5. Five cheap home décor tricks with trim and molding

   www.aol.com/2009/07/27/five-cheap-home-decor...

   For premium support please call: 800-290-4726 more ways to reach us

6. Siding (construction) - Wikipedia

   en.wikipedia.org/wiki/Siding_(construction)

   The foam backing also creates straighter lines when hung, providing a look more like that of wood siding, while remaining low maintenance. Manufacturers report that insulated siding is permeable or "breathable", allowing water vapor to escape, which can protect against rot, mold and mildew, and help maintain healthy indoor air quality .

7. Full-mold casting - Wikipedia

   en.wikipedia.org/wiki/Full-mold_casting

   The pattern is then coated with a refractory material. The coated pattern (2) is placed in a flask and packed carefully with green sand (4) or a chemically bonded sand. Finally, the molten metal (1) is poured into the mold, which vaporizes the foam (3) allowing the metal to fill the entire mold. The vapor is simultaneously extracted from the ...