enow.com Web Search

  1. Ad

    related to: skinner valve potted vs unpotted right engine pressure tester for gas

Search results

  1. Results from the WOW.Com Content Network
  2. Leak-down tester - Wikipedia

    en.wikipedia.org/wiki/Leak-down_tester

    This schematic shows the component parts of a typical leak-down tester. The gauge on the right is held at a standard pressure by adjusting the pressure regulator while the gauge on the left shows an example reading of 85, or 15% leakage. A leak-down tester [2] is essentially a miniature flow meter similar in concept to an air flow bench. The ...

  3. Uniflow steam engine - Wikipedia

    en.wikipedia.org/wiki/Uniflow_steam_engine

    The Casablanca-class escort carrier, the most prolific aircraft carrier design in history, used two 5-cylinder Skinner Unaflow engines, but these were not steeple compounds. A non-compound Skinner Uniflow remained in service until 2013 in the Great Lakes cement carrier SS St. Marys Challenger, installed when the vessel was re-powered in 1950 ...

  4. Uniflow engine - Wikipedia

    en.wikipedia.org/wiki/Uniflow_engine

    Uniflow steam engine, a steam engine with a long uniflow cylinder that receives inlet steam at each end (for a double-acting engine) and exhausts through ports at the centre. Uniflow diesel engine, a two-stroke diesel engine with inlet through piston-ported fixed ports in the lower part of the cylinder, and exhaust through valves in the ...

  5. Engine configuration - Wikipedia

    en.wikipedia.org/wiki/Engine_configuration

    The engine configuration describes the fundamental operating principles by which internal combustion engines are categorized. Piston engines are often categorized by their cylinder layout, valves and camshafts. Wankel engines are often categorized by the number of rotors present. Gas turbine engines are often categorized into turbojets ...

  6. Air flow bench - Wikipedia

    en.wikipedia.org/wiki/Air_flow_bench

    This graph, generated with an engine simulation program, shows how widely the pressures vary in a running engine vs. the steady test pressure of the flow bench. ( Note , on the graph, that, in this case, when the intake valve opens, the cylinder pressure is above atmospheric (nearly 50% above or 1.5 bar or 150 kPa).

  7. Scavenging (engine) - Wikipedia

    en.wikipedia.org/wiki/Scavenging_(engine)

    Scavenging is the process of replacing the exhaust gas in a cylinder of an internal combustion engine with the fresh air/fuel mixture (or fresh air, in the case of direct-injection engines) for the next cycle. If scavenging is incomplete, the remaining exhaust gases can cause improper combustion for the next cycle, leading to reduced power output.

  8. Cutoff (steam engine) - Wikipedia

    en.wikipedia.org/wiki/Cutoff_(steam_engine)

    In a steam engine, cutoff is the point in the piston stroke at which the inlet valve is closed. On a steam locomotive, the cutoff is controlled by the reversing gear.. The point at which the inlet valve closes and stops the entry of steam into the cylinder from the boiler plays a crucial role in the control of a steam engine.

  9. Separator (oil production) - Wikipedia

    en.wikipedia.org/wiki/Separator_(oil_production)

    The valves required for oil and gas separators are oil discharge control valve, water-discharge control valve (three-phase operation), drain valves, block valves, pressure relief valves, and emergency shutdown valves (ESD). ESD valves typically stay in open position for months or years awaiting a command signal to operate.

  1. Ad

    related to: skinner valve potted vs unpotted right engine pressure tester for gas